Weider 831.159830 user manual

Page 33

This chart is provided to help you identify the small parts used in assembly. The number in parenthesis below each part refers to the key number of the part from the PART LIST in the center of this manual. Important:

Some parts may have been pre-assembled for shipping purposes. If you cannot find a part in the parts bags, check to see if it has been pre-assembled.

Note: Assembly is divided into four stages: 1) frame assembly; 2) arm assembly; 3) cable assembly; and 4) seat assembly. The hardware for each assembly stage is packaged separately. Wait until you begin each stage to open that parts bag.

Image 33
Contents SEARS, Roebuck and CO. Hoffman ESTATES, IL Model No Serial NoTable of Contents Important Precautions Decal Before YOU BeginMake Assembly Easier for Yourself AssemblyFrame Assembly Frame AssemblyLocate and open the parts bag labeled Locknuts yet Attaching the Accessories to a Pulley Station AdjustmentsAdjusting the LEG Press Plate Attaching the Curl PADDo not tighten the Nylon Locknuts yet Guides 26. Note Make sure the Top Weight is Guides 26. Make sure the Weights are turnedOn the Short Weight Tube Weights are turned so the pin grooves are On the bottomLocknuts 90. Do not tighten the Nylon Locknuts yet Must be behind the Center Top Frame, as Shown in stepNylon Locknuts yet Nylon Jamnuts 92. Do not tighten the Nylon Locknuts yetAssembly Arm AssemblyLocate and open the parts bag labeled ARM Tighten the Nylon Jamnut the Press FramePages 30 Identify the Butterfly Cable 73. It is approxi Cable AssemblyBack of the Butterfly Upright 4 with a 3/8 Make sure the Long Cable Trap is oriented as ShownOn the back of the Butterfly Upright 4 with a Remove another V-Pulley 34 from the bag Labeled Pulley BAGMake sure the Long Cable Trap is orient Ed as shown Identify the Rear Cable 70. It is approximatelyIdentify the Ab Cable 74. It is approximately Trap is positioned to hold the Cable Groove of the PulleyTrap is positioned to hold the Cable Groove of the Pulley Locknut 90. Make sure the Cable is routed Direction shown Page Page Page 102 Page Locate and open the parts bag labeled Seat Seat AssemblyLeg Press Plate 16 must be on the upper edge Onto the Bolts. Do not tighten the Nylon Locknuts yet Do not tighten the 5/16 Nylon Locknuts YetTighten the Nylon Locknuts yet Locknuts 86. Do not tighten the Nylon Locknuts yetChanging the Weight Setting Weight High Press LEG Butter LOW Pulley ARM FLY ARM Lever Weight Resistance ChartLbs Left Top BottomTightening the Cables Troubleshooting and MaintenancePage Cable Diagrams Cable ID ChartPress Cable 70, 95 1/8 71, 142 1/8 74, 226 1/2 72, 387 5/8 Low Cable Rear Cable Ab Cable Butterfly Cable Model No Full 90 DAY WarrantySEARS, Roebuck and CO., Hoffman ESTATES, IL SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, ILPage Page Part Identification CHART-Model No .159830 R0402A Page Remove this Part LIST/EXPLODED Drawing From the Manual Qty Description Part LIST-Model NoDRAWING-Model No