Weider 831.159830 user manual Frame Assembly, Locate and open the parts bag labeled

Frame Assembly

1.Before beginning, be sure that you have read and understood the information on page 5.

Locate and open the parts bag labeled

“FRAME ASSEMBLY.”

Press a 2” Square Inner Cap (67) into each end of the Butterfly Base (1).

Insert four 5/16” x 2 1/2” Carriage Bolts (75) and a a 3/8” x 3 1/2” Carriage Bolt (95) up through the indicated holes in the Butterfly Base (1). Place the Butterfly Base flat on the floor. Note: If the Bolts fall out, secure them by putting a small piece of tape over the head of each Bolt.

2.Press three 2” Square Inner Caps (67) into the Center Base (2). Insert a 3/8” x 3 1/2” Carriage Bolt (95) up through the indicated hole in the Center Base.

Attach the Center Base (2) to the Butterfly Base (1) with two 5/16” x 2 3/4” Bolts (89), a Medium Support Plate (109), and two 5/16” Nylon Locknuts (86). Do not tighten the Nylon Locknuts yet.

Note: There are three kinds of Support Plates. The main difference between them is the dis- tance between the holes. When you need a Support Plate, find the kind with holes that will fit over the bolts you are using.

3.Press a 2” Square Inner Cap (67) into the end of the Press Base (3).

Insert four 5/16” x 2 1/2” Carriage Bolts (75) up through the indicated holes in the Press Base (3). Insert a 3/8” x 2 1/2” Carriage Bolt (76) and a 3/8” x 4” Carriage Bolt (112) up through the indicated holes at the end of the Press Base.

Attach the Press Base (3) to the Center Base (2) with two 5/16” x 2 3/4” Bolts (89), a Medium Support Plate (109), and two 5/16” Nylon Locknuts (86). Do not tighten the Nylon Locknuts yet.

6

1
					67
	1				95
			75
	75
67
2
89	109
		86			67
1	86	2
			95
3
				86	67
	2
		86			109
	3
					89
			75	76	112
	75