Weider 831.159830 user manual Locknut 90. Make sure the Cable is routed Direction shown

37. Wrap the Ab Cable (74) around a 3 1/2” Pulley	37
(35) in the direction shown. Attach the Pulley to
the indicated bracket on the Center Base (2) with
a 3/8” x 3 3/4” Bolt (101) and a 3/8” Nylon
Locknut (90). Make sure the Cable is routed in			74
the direction shown.		35
Note: The 3/8” x 3 3/4” Bolt (101) must be			101
inserted through both brackets on the Center
Frame (2). Tighten the 3/8” Nylon Locknut (90)
only a few turns onto the Bolt; it will need to			2
be removed in step 39.
			90
38. Wrap the Ab Cable (74) around a 3 1/2” Pulley	38
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the forth set of holes from
the bottom in the indicated pair of Pulley Plates
(32) with a 3/8” x 2” Bolt (93) and a 3/8” Nylon		32
Locknut (90). Make sure the Cable Trap is posi-
		90
tioned to hold the Cable in the groove of the			93
Pulley.		35
		38
		74
39. Remove the 3/8” x 3 3/4” Bolt (101) and the 3/8”	39
Nylon Locknut (90) used in step 37.
Wrap the Ab Cable (74) around a 3 1/2” Pulley (35)			35
in the direction shown. Attach the Pulley to the indi-			101	92
cated bracket on the Center Base (2), and the			74
3 1/2” Pulley (35) used in step 37 to its bracket,		90		35
with the 3/8” x 3 3/4” Bolt (101) and the 3/8” Nylon			35	38
Locknut (90). Note: Make sure the Pulley used
in step 37 is attached as shown.			2 95
Wrap the Ab Cable (74) around a 3 1/2” Pulley
(35) in the direction shown. Slide the Pulley and a
Cable Trap (38) onto the 3/8” x 3 1/2” Carriage
Bolt (95) in the Center Base (2). Secure the
Pulley with a 3/8” Nylon Jamnut (92). Make sure	40
the Cable Trap is positioned to hold the Cable			35
in the groove of the Pulley.
40. Lay the Ab Cable (74) inside the indicated bracket			94
on the Center Base (2). Attach a 3 1/2” Pulley
(35) inside the bracket with a 3/8” x 1 3/4” Bolt
(94) and a 3/8” Nylon Jamnut (92).	92
	Bracket	74		2
	17