Weider WESY59101 user manual Weight Cable Cable ID Stack

Page 26

Weight Cable (72)

	11	Cable ID
	11
9
10	6
	6
12—Weight
Stack
	72	47	75	73
	8
	7
	5
	3
	4	1—Low Pulley
	4
	2
	26

Image 26

Contents Serial Number Decal Under Seat QUESTIONS?Model No. WESY59101 Serial No Customer HOT LineTable of Contents Limited WarrantyMake sure all parts are properly tightened Important PrecautionsReplacement decal Apply the decal in the location shown Ing down Decal shownFor your benefit, read this manual carefully before Using the weight systemBefore YOU Begin DecalArm Assembly AssemblyCable Assembly To open the parts bag for that stageFrame Assembly AssemblyDo not tighten the Nylon Locknuts yet Corner bar of the Press Base Press the Weight Tube Bumper 18 into the Weight TubeSee the inset drawing SlotTighten the Nylon Locknuts used in steps ARM AssemblyLocknuts 50. Do not tighten the Nylon Locknuts yet Bolt and a 3/8 Nylon Locknut HandlesInsert two 2 Square Inner Caps 28 into the Leg Lever Cable AssemblyAble to pivot easily 101Trap is turned to hold the Cable in place Hold the Cable in placeNylon Locknut Frame 9. Attach a 3/8 Flat Washer 48 and aPlates 23 with a 3/8 x 2 Bolt 54 and a 3/8 Wrap the Ab Pulley 47 around another 3 1/2Weight Cable has a bolt, and the other End has a ball on it Be sure Weight Cable is in the groove of the 3 1/2 Pulley4 Bolt 57 and a 3/8 Nylon Jamnut Wrap the Weight Cable 72 around a 3 1/2 PulleyCable Trap is turned to hold the Cable in place Cable in placeBe sure that Cable Trap is turned to hold the Cable in place Remove the preassembled 3/8 x 1 3/4 BoltsDo not tighten the Nylon Locknut yet Place To hold the Cable in placeBe sure Hold the Cable 75 in placeSeat Assembly Locate and open the parts bag labeled Seat AssemblyWelded ADJUSTMENTS, beginning on page 21 of this manualMaintenance on Ab Strap 81 can be attached in the same manner AdjustmentsAttaching the LAT BAR or AB Strap to High Pulley Station Attaching the LAT BAR, AB STRAP, or NylonAttaching the AB Strap to the AB Pulley Station Adjusting the BackrestAdjusting the Curl PAD Weight Resistance Chart Retighten the 1/2 Plain Nut down onto the 1/2 Flat Washer Troubleshooting and MaintenanceTightening the Cables Cable Diagrams Right ArmWeight Cable Cable ID Stack Page Ordering Replacement Parts Part No R0103AFor That Assembly Stage R0103A Pulley 27 Not shown to scale 2 Pulley 24 Not shown to scaleX 3 1/4 Bolt 2 Square Inner Cap 3 Inner Cap 2 x 2 1/2 Inner Cap Save this Part LIST/EXPLODED Drawing for Future Reference Key QtyExploded