Weider WESY59101 user manual Save this Part LIST/EXPLODED Drawing for Future Reference

Page 33

REMOVE THIS PART LIST/EXPLODED DRAWING FROM THE MANUAL.

SAVE THIS PART LIST/EXPLODED DRAWING FOR FUTURE REFERENCE

1 8

Image 33

Contents Model No. WESY59101 Serial No QUESTIONS?Serial Number Decal Under Seat Customer HOT LineLimited Warranty Table of ContentsReplacement decal Apply the decal in the location shown Important PrecautionsMake sure all parts are properly tightened Ing down Decal shownBefore YOU Begin Using the weight systemFor your benefit, read this manual carefully before DecalCable Assembly AssemblyArm Assembly To open the parts bag for that stageAssembly Frame AssemblyDo not tighten the Nylon Locknuts yet See the inset drawing Press the Weight Tube Bumper 18 into the Weight TubeCorner bar of the Press Base SlotARM Assembly Locknuts 50. Do not tighten the Nylon Locknuts yetTighten the Nylon Locknuts used in steps Handles Bolt and a 3/8 Nylon LocknutAble to pivot easily Cable AssemblyInsert two 2 Square Inner Caps 28 into the Leg Lever 101Hold the Cable in place Trap is turned to hold the Cable in placePlates 23 with a 3/8 x 2 Bolt 54 and a 3/8 Frame 9. Attach a 3/8 Flat Washer 48 and aNylon Locknut Wrap the Ab Pulley 47 around another 3 1/2Be sure Weight Cable is in the groove of the 3 1/2 Pulley Weight Cable has a bolt, and the other End has a ball on itCable Trap is turned to hold the Cable in place Wrap the Weight Cable 72 around a 3 1/2 Pulley4 Bolt 57 and a 3/8 Nylon Jamnut Cable in placeRemove the preassembled 3/8 x 1 3/4 Bolts Be sure that Cable Trap is turned to hold the Cable in placeDo not tighten the Nylon Locknut yet Be sure To hold the Cable in placePlace Hold the Cable 75 in placeLocate and open the parts bag labeled Seat Assembly Seat AssemblyADJUSTMENTS, beginning on page 21 of this manual Maintenance onWelded Attaching the LAT BAR or AB Strap to High Pulley Station AdjustmentsAb Strap 81 can be attached in the same manner Attaching the LAT BAR, AB STRAP, or NylonAdjusting the Backrest Adjusting the Curl PADAttaching the AB Strap to the AB Pulley Station Weight Resistance Chart Troubleshooting and Maintenance Tightening the CablesRetighten the 1/2 Plain Nut down onto the 1/2 Flat Washer Right Arm Cable DiagramsWeight Cable Cable ID Stack Page Part No R0103A Ordering Replacement PartsFor That Assembly Stage Pulley 27 Not shown to scale 2 Pulley 24 Not shown to scale R0103AX 3 1/4 Bolt 2 Square Inner Cap 3 Inner Cap 2 x 2 1/2 Inner Cap Save this Part LIST/EXPLODED Drawing for Future Reference Qty KeyExploded