Miele W 1930I operating instructions What to do if Cause Remedy

Problem solving guide

What to do if, . . .	Cause . . .	Remedy . . .
. . . the “Pre-wash”, “Main	There is an internal problem.	Restart the program. If the
		indicator lamp starts flashing
wash” or “Rinse 1-2” indicator
		again, call the Service Dept.
lamp is flashing?
. . . The “Rinse & hold” indica-	The spin speed selector has	Select a spin speed setting.
tor lamp is flashing?	been set to “Without final spin”.
. . . The “Final spin” indicator	The final spin has not taken	– Redistribute the laundry load.
	place. The machine detected	– Select a spin speed.
lamp is flashing?
	an imbalance.
		– Turn the program selector to
		“Spin”.
. . . The “ON” indicator lamp	The child-safety feature is	Go back to the program
	activated, and the program has	originally selected.
is flashing?
	been changed.
. . . The wash is too wet after	The spin speed selected was	Select a higher spin speed next
	too low.	time.
the final spin?
	The load was not evenly	Mix large and small items in a
	distributed in the drum, and the	load to avoid imbalance.
	laundry was spun at a reduced
	speed to protect the machine.
	The drain pump or lint trap is	Clean the drain pump or lint
	clogged.	trap.
. . . The machine shakes dur-	The four feet are not resting	Level the machine (see
	evenly on the floor.	Installation Section).
ing the spin cycle?
	The shipping struts have not	Remove the shipping struts.
	been removed.

26