Miele W 1930I operating instructions Water hardness reminder

Page 39

Installation

Any residual water left in the machine from the factory test- ing process can be flushed out as follows:

Do not put any laundry in the ma- chine.

Add a small amount of detergent to compartment j.

Turn on the machine.

Press the “Rapid wash” button.

Turn the program selector to the “COTTONS 140°F” program.

Any residual water will be flushed out during water the program.

Water hardness reminder

The amount of detergent needed to wash clothes depends on various fac- tors, including the water hardness in your area. You can set the water hard- ness dial in the detergent dispenser as a reminder.

Turn the dial to the desired setting. Use the tool supplied with the ma- chine. It is located behind the deter- gent drawer, on the left hand side (see Cleaning and Care) water.

1 = soft, 4 = very hard

39

Page 38 Page 40
Image 39
Page 38 Page 40
Contents For the W 1930i Washing Machine Contents Guide to the machine Detergent dispenser drawer Important safety instructions Disposal of your old machine Disposal of the packing materialEconomy Economical usagePreparing the Laundry Before washingPrepare the wash load Close the machine door To start a programPress the Door button to open the door Load the machine Recommended load sizes are noted belowEnd of Program After washingClose the drum door To change an incorrectly selected program To cancel a programChanging the program sequence To interrupt a programAdding detergent Using the Starch program to dis- pense liquid starch Adding fabric softener or starchStarch Program selection 11 lbs Graduated rinse Program sequenceExplanations Interim rinseWoolens Starch Spin Fine rinseGraduated spin Final spinTumble dry Textile care symbolsTemperature Conversion Chart Washing CGentle wash Additional optionsPre-wash Water plusRemaining time Delay start/Time remaining indicatorDelay Start Time display HminUser Maintenance Instructions Cleaning and care Cleaning the washing machineCleaning the detergent drawer Cleaning the drain pump and lint trap Cleaning and careCleaning and Care Cleaning the water inlet filters To clean the filter in the inlet hoseTo clean the filter in the inlet valve Check p / q indi Problem solving guideProgram does not Start?What to do if Cause Remedy Build-up of foam? Into the machine? Large residues of deterDrawer? There is an excessiveAfter washing pilling ap Grey greasy particlesCling to washed laundry? Give the required result?Opening the drum door in the event of a power failure Electric socket To check water pressureAfter sales service Removing the shipping struts Installation Instructions InstallationInstallation surface InstallationInstallation Building Levelling the machinePlease note the following Matching the control panel to the adjacent washer frontsPlate locations 1 and 2 only Installing the front panelInstallation Washer-Dryer stack Sizing the toekick Installing the toekickWater hardness reminder Connection to the drain sys- tem PlumbingGrounding Instructions Electrical connectionNo water intake through compartment Operating Instructions Programmable functionsHigh water level only in Cottons rinses 5th Rinse in the Cottons programStep Programmable functionsDesired function AHigh water level B5th rinse cycle DProgram Lock Child safety featureAdditional rinse in Rapid wash To check if the function has been stored Deleting the additional func- tionsCarry out Steps 1 to Dimensions Installation Instructions Technical dataTechnical data Page Page
Top Page Image Contents