Miele W 1930I operating instructions After sales service

Page 31

After sales service

If problems occur that cannot be easily remedied, or if the appliance is under warranty, please contact:

Your Miele Dealer or

The Miele Service Department (see back cover).

When contacting the Service Depart- ment, please have the model and serial numbers of your appliance available, both of which can be found on the data- plate visible when the door front is opend above the porthole glass.

31

Image 31
Contents For the W 1930i Washing Machine Contents Guide to the machine Detergent dispenser drawer Important safety instructions Disposal of your old machine Disposal of the packing materialEconomy Economical usageBefore washing Preparing the LaundryPrepare the wash load Close the machine door To start a programPress the Door button to open the door Load the machine Recommended load sizes are noted belowAfter washing End of ProgramClose the drum door To change an incorrectly selected program To cancel a programChanging the program sequence To interrupt a programAdding detergent Adding fabric softener or starch Using the Starch program to dis- pense liquid starchStarch Program selection 11 lbs Graduated rinse Program sequenceExplanations Interim rinseWoolens Starch Spin Fine rinseGraduated spin Final spinTumble dry Textile care symbolsTemperature Conversion Chart Washing CGentle wash Additional optionsPre-wash Water plusRemaining time Delay start/Time remaining indicatorDelay Start Time display HminCleaning the washing machine User Maintenance Instructions Cleaning and careCleaning the detergent drawer Cleaning the drain pump and lint trap Cleaning and careCleaning and Care To clean the filter in the inlet hose Cleaning the water inlet filtersTo clean the filter in the inlet valve Check p / q indi Problem solving guideProgram does not Start?What to do if Cause Remedy Build-up of foam? Into the machine? Large residues of deterDrawer? There is an excessive After washing pilling ap Grey greasy particles Cling to washed laundry? Give the required result?Opening the drum door in the event of a power failure Electric socket To check water pressureAfter sales service Removing the shipping struts Installation Instructions InstallationInstallation surface InstallationInstallation Building Levelling the machinePlease note the following Matching the control panel to the adjacent washer frontsPlate locations 1 and 2 only Installing the front panelInstallation Washer-Dryer stack Sizing the toekick Installing the toekickWater hardness reminder Connection to the drain sys- tem PlumbingGrounding Instructions Electrical connectionNo water intake through compartment Operating Instructions Programmable functionsHigh water level only in Cottons rinses 5th Rinse in the Cottons programStep Programmable functionsDesired function AHigh water level B5th rinse cycle DProgram Lock Child safety featureAdditional rinse in Rapid wash Deleting the additional func- tions To check if the function has been storedCarry out Steps 1 to Dimensions Installation Instructions Technical dataTechnical data Page Page