Miele T 7744 C Problem Possible cause Remedy, Airways indicator, Light comes on, Programme, Stops

Page 29

Problem solving guide

Problem

Possible cause

Remedy

The Clean out

This indicator light comes on

– Cleaning the fluff filters is

airways indicator

to warn you that the dryer is

usually all that is required.

light comes on.

not working efficiently.

However, if the Clean out

 

Possible cause: The fluff

airways indicator light

 

filters are clogged with fluff

does not go out after you

 

or with detergent residues.

have cleaned the filters,

 

 

then also check all the

 

 

possible causes

 

 

described under "The

 

 

drying process goes on

 

 

too long or even switches

 

 

off".

 

 

To switch off the indicator

 

 

light:

 

 

– Open and close the door.

 

 

The Clean out airways

 

 

indicator light can be

 

 

deactivated (see

 

 

"Programmable functions").

The programme

See above for possible

To switch off the indicator

stops.

causes and their remedies.

light:

The Clean out

 

– Open and close the door.

airways indicator

 

– Switch the dryer off and

light comes on.

 

then back on again.

The buzzer sounds.

 

– Then start the programme

 

 

again.

 

 

– If the Clean out airways

 

 

indicator light comes on

 

 

again, contact the Miele

 

 

Service Dept.

The Empty out

The condensed water

– Empty out the condensed

container indicator

container is full or there is

water container.

light comes on.

kink in the drain hose.

– Check the drain hose.

The buzzer sounds.

 

To switch off the indicator

 

 

light:

 

 

– Open and close the door.

29

Image 29
Contents Operating instructions For condenser tumble dryer T 7744 C Disposal of the packing material Caring for the environmentDisposal of your old appliance Energy saving tipsContents Contents Correct application Safety with childrenTechnical safety Correct use Page Accessories Control panel Operating the tumble dryerDisplay Check lightsProgrammable functions Delay startProgramme duration / Estimated time remaining Tips on drying Care symbolsBrief instructions How to dry correctlySort the laundry Turn on the tumble dryerSelect any additional options Select a programmeBefore the end of a programme Remove the laundry when the programme has finishedStart the programme Low temperature Extra options / Delay startDelay start BuzzerProgramme chart Smoothing Woollens handcareAutomatic ShirtsWarm air Cool airChanging the programme sequence Cancelling a programmeChanging a programme while it is running Interrupting a programmeTo deactivate the lock Electronic system lockTo activate the lock Emptying the condensed water container Cleaning and carePull out the container Empty the containerCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryer Removing the condenser unit Cleaning the condenser unit Checking the condenser unit Replacing the condenser unit Check and fault messages Problem solving guideAirways indicator Problem Possible cause RemedyTo switch off the indicator Buzzer sounds To switch off the indicator LightOther problems Been cleaned Problem Possible cause Remedy Water leaks fromDryer after Condenser unit hasStart when switched on Problem Possible cause Remedy Tumble dryer fails toInterior drum Lighting does not comeChanging the lamp Future updates PC After sales serviceGuarantee Optional accessoriesFront view Installation and connectionWasher-dryer stack Rear view Installation siteTransporting the machine to its installation site Room ventilation Before moving the machine again e.g. when moving houseLevelling the machine Arranging the drain hose External condensed water outletGeneral notes External drainage via a sink or gully Installation conditions requiring a non-return valveInstallation and connection Electrical connection U.K Non-rewireable plugs BSElectrical connection Smoothing Consumption dataTechnical data Programmable functions For changing default settings Extending the range of the drying levels Programmable functionsFollow steps a to F to programme and store in memory Altering the volume of the buzzerNormal buzzer Default setting Loud buzzer Memory function Memory deactivated Default setting Memory activatedCooling down time will be ten minutes longer Extending the cooling down timeDefault setting Clean out airways indicatorKeypad tone Adjusting the dryers electronics for very soft water Alteration rights reserved/1807 Nr 737 070