Miele T 7744 C Problem Possible cause Remedy Tumble dryer fails to, Start when switched on

Page 32

Problem solving guide

Problem

Possible cause

Remedy

The tumble dryer fails to

No obvious cause.

– Is the dryer switched

start when switched on.

 

on

 

 

– Is the plug correctly

 

 

inserted into the socket

 

 

and switched on

 

 

– Is the door closed

 

 

properly

 

 

– Has the fuse or circuit

 

 

breaker tripped

The interior drum

The lighting switches off

Switch the dryer off and

lighting does not come

automatically (to save

then on again.

on.

energy).

 

 

The lamp needs

Change the lamp as

 

changing.

described at the end of

 

 

this section.

32

Image 32
Contents Operating instructions For condenser tumble dryer T 7744 C Caring for the environment Disposal of the packing materialDisposal of your old appliance Energy saving tipsContents Contents Correct application Safety with childrenTechnical safety Correct use Page Accessories Operating the tumble dryer Control panelDisplay Check lightsProgrammable functions Delay startProgramme duration / Estimated time remaining Care symbols Tips on dryingHow to dry correctly Brief instructionsSort the laundry Turn on the tumble dryerSelect a programme Select any additional optionsBefore the end of a programme Remove the laundry when the programme has finishedStart the programme Extra options / Delay start Low temperatureDelay start BuzzerProgramme chart Woollens handcare SmoothingAutomatic ShirtsCool air Warm airCancelling a programme Changing the programme sequenceChanging a programme while it is running Interrupting a programmeTo deactivate the lock Electronic system lockTo activate the lock Cleaning and care Emptying the condensed water containerPull out the container Empty the containerCleaning the fluff filters Cleaning them whilst dryCleaning them with water Cleaning the tumble dryer Cleaning the condenser unit Removing the condenser unitChecking the condenser unit Replacing the condenser unit Problem solving guide Check and fault messagesProblem Possible cause Remedy Airways indicatorTo switch off the indicator Buzzer sounds To switch off the indicator LightOther problems Problem Possible cause Remedy Water leaks from Been cleanedDryer after Condenser unit hasProblem Possible cause Remedy Tumble dryer fails to Start when switched onInterior drum Lighting does not comeChanging the lamp After sales service Future updates PCGuarantee Optional accessoriesInstallation and connection Front viewWasher-dryer stack Rear view Installation siteTransporting the machine to its installation site Room ventilation Before moving the machine again e.g. when moving houseLevelling the machine Arranging the drain hose External condensed water outletGeneral notes Installation conditions requiring a non-return valve External drainage via a sink or gullyInstallation and connection Electrical connection U.K Non-rewireable plugs BSElectrical connection Consumption data SmoothingTechnical data Programmable functions For changing default settings Programmable functions Extending the range of the drying levelsFollow steps a to F to programme and store in memory Altering the volume of the buzzerNormal buzzer Default setting Loud buzzer Memory deactivated Default setting Memory activated Memory functionExtending the cooling down time Cooling down time will be ten minutes longerClean out airways indicator Default settingKeypad tone Adjusting the dryers electronics for very soft water Alteration rights reserved/1807 Nr 737 070