Miele T 7744 C Rear view Installation site, Transporting the machine to its installation site

Page 36

Installation and connection

Rear view

Installation site

aProtruding lid for holding when moving the machine (see arrows)

bAir inlet vent for cooling the condenser unit

cMains connection cable

dExternal drainage of the condensed water

eAccessories for connection to a sink drain outlet

,The machine lid must not be removed.

The dryer can be pushed under a worktop with its lid in place, providing the worktop is high enough.

,Make sure the dryer door can be opened without hindrance after installation.

Transporting the machine to its installation site

When moving the machine, you can hold it by the lid where it protrudes to the rear of the dryer. To manoeuvre the dryer out of its packing case to its installation site you will also need to hold it by the front feet.

Washer-dryer stack

The tumble dryer can also be combined with a Miele washing machine in a washer-dryer stack. The appropriate "WTV" stacking kit (available to order) to match your dryer is required.

,Stacking kits must only be installed by a suitably qualified fitter.

36

Image 36

Contents Operating instructions For condenser tumble dryer T 7744 C Caring for the environment Disposal of the packing materialDisposal of your old appliance Energy saving tipsContents Contents Safety with children Technical safetyCorrect application Correct use Page Accessories Operating the tumble dryer Control panelDisplay Check lightsDelay start Programme duration / Estimated time remainingProgrammable functions Care symbols Tips on dryingHow to dry correctly Brief instructionsSort the laundry Turn on the tumble dryerSelect a programme Select any additional optionsRemove the laundry when the programme has finished Start the programmeBefore the end of a programme Extra options / Delay start Low temperatureDelay start BuzzerProgramme chart Woollens handcare SmoothingAutomatic ShirtsCool air Warm airCancelling a programme Changing the programme sequenceChanging a programme while it is running Interrupting a programmeElectronic system lock To activate the lockTo deactivate the lock Cleaning and care Emptying the condensed water containerPull out the container Empty the containerCleaning the fluff filters Cleaning them whilst dryCleaning them with water Cleaning the tumble dryer Cleaning the condenser unit Removing the condenser unitChecking the condenser unit Replacing the condenser unit Problem solving guide Check and fault messagesProblem Possible cause Remedy Airways indicatorTo switch off the indicator Buzzer sounds To switch off the indicator LightOther problems Problem Possible cause Remedy Water leaks from Been cleanedDryer after Condenser unit hasProblem Possible cause Remedy Tumble dryer fails to Start when switched onInterior drum Lighting does not comeChanging the lamp After sales service Future updates PCGuarantee Optional accessoriesInstallation and connection Front viewRear view Installation site Transporting the machine to its installation siteWasher-dryer stack Before moving the machine again e.g. when moving house Levelling the machineRoom ventilation External condensed water outlet General notesArranging the drain hose Installation conditions requiring a non-return valve External drainage via a sink or gullyInstallation and connection Non-rewireable plugs BS Electrical connectionElectrical connection U.K Consumption data SmoothingTechnical data Programmable functions For changing default settings Programmable functions Extending the range of the drying levelsAltering the volume of the buzzer Normal buzzer Default setting Loud buzzerFollow steps a to F to programme and store in memory Memory deactivated Default setting Memory activated Memory functionExtending the cooling down time Cooling down time will be ten minutes longerClean out airways indicator Default settingKeypad tone Adjusting the dryers electronics for very soft water Alteration rights reserved/1807 Nr 737 070