Installation and connection
Levelling the machine
The machine must be perfectly level to ensure safe and proper operation.
^The screw feet can be adjusted to compensate for any unevenness in the floor.
,The air inlet and outlet vents on the front and back of the machine must not be covered as this would prevent sufficient ventilation for cooling the condenser unit.
Room ventilation
The air which is taken in when the dryer is in operation is blown out of the vents on the front of the machine and warms up the air in the room.
It is very important, particulary if the room is small, to ensure adequate ventilation. Opening a window, for example, will allow more air to enter the room. Otherwise running times and energy consumption could be increased.
Before moving the machine again (e.g. when moving house)
After each use a small quantity of condensed water will collect in the area around the pump. This water can run out if the machine is tipped up when it is being moved. It is a good idea to run the Cool air programme for approximately 1 minute before moving the machine. Any remaining condensed water will then be fed into the condensed water container or out through the drain hose.
37