Programmable functions
Adjusting the dryer's electronics for very soft water
,In some areas of the UK, water is extremely soft which can affect the sensitivity of the control electronics. If the dryer is installed in an area with very soft water, you should contact your local water supplier for information and advice regarding water hardness and water conductivity. If the water conductivity is less than 150 µS, the following programmable function will need to be activated.
Important. This programmable function should not be activated if, despite the water being extremely soft (as would be the case if a water softener were used), its conductivity is greater than 150 µS.
Follow steps A to F to programme and store in memory.
Before you begin, first ensure that:
–The tumble dryer is switched off.
–The door is closed.
APress the Start/Stop button and keep it pressed in whilst carrying out steps
BPress the
Wait until the indicator light for the Start/Stop button lights up constantly . . .
C. . . and then release the Start/Stop button.
DPress the Low temperature button six times.
–The Low temperature indicator light will flash on and off slowly once and will then flash on and off quickly twice.
–P and 0 (default setting) will flash alternately in the display.
The number which appears alternately in the display with P means:
0Default setting
iAdjusted for very soft water (with low conductivity)
(The Automatic indicator light will also flash)
EPressing the Start/Stop button switches from one to the other.
FSwitch the dryer off with the
The setting you have selected is now stored in memory. You can change it again at any time.
51