Whirlpool GVW9959K-0 manual Tab

6.There is a tab on the underside of the inner wash plate that corresponds to a slot on the universal joint. These should fit together when reassembling the inner wash plate over the universal joint.

U-Joint

Grommets

Tab

Tab Fig. 3-19

NOTE: Do not rotate the inner wash plate when reassembling to the universal joint. Rotating the plate may move the leveler to it’s tilted position which may cause the grommets to slip.

7.There is a tab on the outer ring of the inner wash plate that fits into a corresponding hole in the inner ring of the outer wash plate. Install the bolts in the order indicated in Figure 3-20. The proper torque setting for these bolts is 100 in. - lbs.

Alignment

Hole

Seal

Tab

Fig. 3-20

6

3

1

24

5

8.Install wash dome, aligning the four (4) tabs with the slots in the outer wash plate.

9.There are three (3) tabs on the outer edge of the balance ring that must fit into corresponding slots in the basket.

Tab Slot

Fig. 3-21

10. Align cut-out in tub ring with recirculating tube and snap ring onto outer tub.

38