Whirlpool AAV4000AW manual Care & Cleaning

Page 72

Special Features

Unbalanced Spin Load

Compensator

Your new washer is designed to handle out-of-balance loads without shutting down or interrupting the washing cycle.

For this reason, the cycle will always be completed. If heavier fabrics in such out-of-balance loads should ever contain excessive moisture at the completion of the cycle, redistribute the clothes in the washer and reset the control dial for the final spin period.

Overload Protector

A built-in protector automatically shuts off the washer motor in case of an overload. This can occur if:

The load being washed is too heavy.

Too many appliances are plugged into the line operating your washer.

A low voltage condition exists on the line.

Lid is opened and closed repeatedly.

The overload protector permits the washer to start again when the motor has cooled to a safe operating temperature.

If the motor stops repeatedly, call your service technician.

Care & Cleaning

1.After washing, leave the lid open until the interior is dry.

2.Check hoses to be sure there are no kinks or knots.

3.Your washer should not be installed where temperatures will go below freezing, as damage to the washer could result.

4.To clean, occasionally wipe exterior with a clean damp sponge or cloth. Do not use polish on plastic parts.

5.Lifetime lubrication is done at the factory, so your washer never needs to be oiled or greased.

6.Do not lay heavy or sharp objects on top of your washer.

7.The top of the washer should not be used for removing stains from garments. Some stain removers, such as rust remover, will mar the finish.

8.Remove pins, buckles or other sharp objects from clothes to prevent scratching interior parts.

9.Clothes should not be stored in washer.

10.Bleach, detergent, solvents, etc. spilled on the top of your washer that are allowed to remain will remove the glossy finish. Remove all spills with a damp, soft cloth.

11.If you close your home for the winter, have a service technician drain the washer. Unplug cord from electrical outlet and disconnect hoses from faucets.

13

Cleaning the Interior

Clean the interior of the washer periodically to remove any dirt, soil, odor, mold, mildew or bacteria residue that may remain in the washer as a result of washing clothes. We recommend taking the following steps every 60 to 120 days to clean and freshen your washer interior. The frequency with which the washer should be cleaned and freshened depends on factors such as usage, the amount of dirt, soil or bacteria being run through your washer, or the use of cold water. Failure to follow these instructions may result in unsatisfactory conditions, including unpleasant odor and/or permanent stains on the washer or washload.

To clean and freshen the washer interior:

1.Add a measured amount of chlorine bleach to the bleach dispenser, following package directions.

2.Add 1/4 cup of detergent to the tub.

3.Run the washer without a load through a complete cycle using hot water.

4.Repeat the process if necessary.

B–32

16026502

©2005 Maytag Services

Image 72
Contents Service Customer Service Support Center Important InformationGeneral Information Important Safety Information About Ground Wires General Information Related PublicationsProper Grounding and Polarization of 120 Volts Wall Outlets Grounding Instructions ExplanationService Parts and AccessoriesExtended Service Plan Model IdentificationWasher Nomenclature Troubleshooting Procedures Enter Service Mode Exit Service Mode Console Switch Test CON’T Model Code Chart Mechanical Control Version Component Testing Information Mechanical Controls Service Specifications Disassembly Procedures Console DisassemblyDrain Pump/Belt Removal Lid Switch Removal Top Cover RemovalHinge/Lid Removal Water Valve Removal Dispenser RemovalFront Panel Removal Motor Removal Flume/Thermistor RemovalTub Top Removal Agitator/Spinner/Outer Tub/Transmission RemovalRemove Pressure Switch Hose from fitting on Outer Tub Seal/Transmission Disassembly Brake Disassembly Drive Pulley and Cam RemovalTub Seal Replacement Spin Bearing ReplacementOil Seal Replacement Snubber/Brake AssemblyInstalling Thrust Bearing Base ReplacementBrake Adjustment Transmission OperationDetermine Brake Rotor Condition To Adjust Brake Disengagement Thrust Washer PlacementTo Check Brake Disengagement Appendix a Maytag Services Automatic Washing Machine U T I O N S Items Included/Articles inclus/Artículos Incluidos Installation/Installation/Instalación Optional/En option/Opcional Stable go to Warm Gurgling Gargouillis Gorgoteo Appendix B 16026502 Washer What You Need to Know About Safety Instructions Recognize Safety Symbols, Words, LabelsRead all instructions before using the appliance Detergent LoadingOperating Tips Additional TipsSelect Wash/Rinse Temperature Select Water LevelSelect Cycle Pull Control Dial Out to StartRegular Cycle No Iron Fabrics CycleUsing the Controls 3 Speed Combo Models Quick Wash CycleSelect Options if desired Extra RinseUsing the Controls Getting StartedEnd of Cycle Signal Select OptionsSoil Level/Time Selection Fabric Selection Start the WasherSafety Spin Liquid Bleach DispenserFabric Softener Dispenser Automatic Lint Filtering SystemCleaning the Interior Unbalanced Spin Load CompensatorOverload Protector Troubleshooting 16026502 Table of Contents Use & Care GuideImportant Safety Instructions Read all instructions before using the appliance Operating Tips Operating Tips Using the Controls 3 Speed Select Models End of Cycle Signal select models Wrinkle Control CycleDelicates Cycle Using the Controls 4 Speed Select Models Select Wash/Spin SpeedWrinkle Control Hot/Cold White and heavily soiled, color-fast Soil Selection Select Options Finger Faucet select models Care & Cleaning Troubleshooting 16026502 Use & Care Guide Important Safety Instructions Read all instructions before using the appliance Select Cycle and Water Temperature Select Load SizeCottons Cycle WRINKLE-FREE Fabrics CycleCycle Time Temps Using the Controls 3 Speed Combo Models Select WASH/RINSE TempSelect Cycle Using the Controls 4 Speed Combo Models Extra Rinse Soak CycleOperating Tips Liquid Dispenser select models Finger Faucet select modelsSpecial Features Troubleshooting 16026502 Washer CW-3Important Safety Instructions Read all instructions before using the appliance Small 1/2 Full Medium 3/4 Full Large Select Extra Rinse if desired Wrinkle-Free Clothes CycleUsing the Controls 3 Speed Combo with Stain Cleaner Models Select SignalStain Cleaner Cycle Regular/Delicates CycleOperating Tips Stain Cleaner Cycle select models Liquid DispenserCare & Cleaning Fills with the Wrong