Special Features
Liquid Bleach Dispenser
The dispenser automatically dilutes liquid chlorine bleach before it reaches your wash load.
To use, follow these steps:
1.Measure liquid chlorine bleach carefully, following the instructions on the bottle.
2.Pour liquid chlorine bleach into bleach dispenser before adding the load. Avoid splashing or
Notes:
•Never pour undiluted liquid chlorine bleach directly onto the load or into the wash tub. It is a powerful chemical and can cause fabric damage, such as tearing or color loss, if not used properly.
•If you prefer to use
Liquid Dispenser (select models)
The dispenser may be used for fabric softener with most cycles or liquid detergent with the SOAK cycle (select models). The liquid dispenser should be cleaned before and after each use of liquid detergent. The dispenser automatically releases the liquid at the proper time during the cycle.
To use, follow these steps:
1.Pour a measured amount of desired liquid into the dispenser to fill line only.
2.If liquid comes below line, add warm water.
If it is necessary to clean the dispenser:
1.Pull the dispenser off of the top of the agitator.
2.Soak for one hour (in sink or container) in hot water and dishwashing liquid.
3.Hold hands over top and bottom of dispenser and shake to loosen buildup.
4.Rinse with clean, hot water.
5.Repeat process if necessary.
6.Replace dispenser on agitator.
Do not use dishwashing liquid inside the washer. Oversudsing can occur.
SOAK Cycle (select models)
This cycle eliminates the inconvenience of soaking stained loads before they are placed in the washer.
To use, follow these steps:
1.Add liquid or granular detergent to the washtub.
2.Add the load.
3.Add liquid detergent only to the Liquid Dispenser in the top of the agitator.
4.Set the control dial to Start in the SOAK Cycle.
The load will soak for 30 minutes with brief periods of agitation. The water is then spun out and clean wash water is added along with the liquid detergent for a
Safety Spin
If for any reason you open the washer lid when the washer is in a spin or extract period, the operation will immediately stop. This is for your personal safety. If your washer does not stop, call your service technician immediately. When the lid is closed, the operation will automatically resume.
Finger Faucet (select models)
Provides a flow of water when holding the switch in the On position.
10
©2005 Maytag Services | 16026502 |