SERVICE AND TROUBLESHOOTING CONT.
CHECK THESE POINTS IF YOUR MAYTAG NEPTUNE® WASHER...
Won’t Tumble
Door Locked Shut; Will Not Open
Is Noisy
•Check fuse or reset electricity supply.
•Open and close the door and press the Start/Pause touchpad. For your safety, the clothes washer will not tumble or spin unless the door is closed.
•Press the Start/Pause touchpad to stop the washer.
•Pull on the door indentation opposite the hinges.
•To emergency unlock the door, pull on the green rip cord located in the opening just inside the front end of the detergent dispenser. It may be necessary to remove the 4 cover screws and remove the dispenser cover to access this cord.
•Clothes washer should be leveled properly as outlined in installation instructions.
•Weak floors can cause vibration and walking.
•Be sure rubber feet are installed on leveling legs.
•Check that the leveling leg lock nuts are tightened.
•For information on normal operating sounds, see page 18.
17