Maytag MAV-3 Select Cycle, Select Options if desired, Pull Control Dial Out to Start

Control features vary by model.

STEP 4

Select Cycle

To select a cycle, push the control dial in (off position) and turn it to the right (clockwise) until the pointer is at the soil level needed for the wash load.

Important: For optimum fabric care, the appropriate wash and spin speed for the load type must be selected using the wash/spin speed knob.

Regular Cycle

This cycle provides up to 14 minutes of agitation. Select the Regular Wash/Spin Speed setting.

Wrinkle Control

This cycle is designed for most loads. For lightly to normally soiled garments. Select the Wrinkle Control Wash/Spin Speed setting.

Delicates Cycle

Delicates is designed for items requiring delicate wash action. Select the Delicate Wash/Spin Speed setting.

Soak Only (select models)

Provides 4 minutes of agitation, then soak. Avoid extended soaking – soak for 30 minutes or less. The control dial must be manually advanced to a spin setting to spin and drain the water.

STEP 5

Select Options (if desired)

Extra Rinse

When the knob is in the On position, an additional rinse at the end of the Regular, Wrinkle Control and Delicates cycles is provided to more completely remove laundry additives, suds, perfumes, etc.

End of Cycle Signal (select models)

The end of cycle signal will sound once the cycle is completed. The end of cycle signal can be canceled by setting the switch to Off.

STEP 6

Pull Control Dial Out to Start

You may stop the washer at any time by simply pushing the control dial in. Therefore it is possible to obtain a non-agitated soak or to shorten, skip or repeat any part of a cycle. The control dial must be pushed in (off position) when you change the setting.

Note: Do not attempt to turn the control dial counterclockwise. Damage to the timer will result.

6