Reverse the door handle

1.Place the outer door assembly face down on work space.

2.Remove the 2 screws that hold the door handle and the

2 screws holding the hole plugs. If hole plugs do not easily fall out after screws are removed, insert a small screwdriver into the holes and gently push the plugs out.

A. Door handle

B. Hole plugs

3.Move the door handle to the other side and reattach with the 2 screws removed from the door handle in Step 2.

4.Move the hole plugs to the new hinge side and attach with the 2 screws removed from the hole plugs in Step 2.

Reinstalling the door

1.Check for fingerprints on the glass. Clean if necessary.

2.Place the inner door assembly into the outer door assembly. Align the hinge cover and hinge in the openings on each side. To fit correctly, the inside door assembly edge is completely inside the outside door assembly edge.

3.Reassemble the inner and outer door assemblies with the 6 screws.

4= Use a small flat-blade screwdriver to remove plug strip from the door opening. Slide the head of the screwdriver under the top portion of the plug strip, being careful not to scratch the dryer surface. Lift up. Repeat in the middle and at the bottom. Remove the plug strip in the door opening and insert in the opposite side.

5.Insert a screw in the 2nd opening from the top of the hinge opening and partially tighten. Hang the door by placing the top hinge keyhole over the 2nd screw head and tighten the

screw. By putting this screw in first, the door will hang in place while you insert and tighten the remaining 4 screws.

A. Dryer door

B.Dryer

C. Insert this screw first

6.Close the door and check that it latches securely.

1.Check to be sure all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check to be sure you have all of your tools.

3.Dispose of/recycle all packaging materials.

4.Check the dryer'sfinal location. Be sure the vent is not crushed or kinked.

5.Check to be sure the dryer is level. See "Level Dryer."

6.Plug into a grounded outlet. Turn on power.

7.Remove the blue protective film on the console and any tape remaining on the dryer.

8.Read "Dryer Use."

9.Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.

10.Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

•Controls are set in a running or "On" position.

•Start button has been pushed firmly.

•Dryer is plugged into a grounded outlet.

•Electrical supply is connected.

•House fuse is intact and tight, or circuit breaker has not tripped.

•Dryer door is closed.

11.When the dryer has been running for 5 minutes, open the dryer door and feel for heat.

If you do not feel heat, turn off the dryer and check the following:

•There may be 2 fuses or circuit breakers for the dryer. Check to make sure both fuses are intact and tight, or that both circuit breakers have not tripped. If there is still no heat, contact a qualified technician.

NOTE: You may notice a burning odor when the dryer is first heated. This odor is common when the heating element is first used. The odor will go away.