D6
FRYING FROZEN FOODS
1.Due to their extremely low temperature, frozen foods inevitably lower the temperature of the oil. For good results each time you fry, we recommend you don’t exceed the maximum quantities set out in the following table.
2.Frozen foods are frequently covered with a coa- ting of ice crystals, which should be removed
before frying. Lower the basket very slowly into the oil in order to ensure that the oil does not boil over. Before lowering the basket into the oil, ensure that the lid is securely closed.
3.To obtain best results, do not exceed recommended max. quantity of food.
The cooking time shown in this table are approximate, and may vary according to the initial temperature of the food and to the cooking temperature recommended on the packet.
| Food | Max. quantity | Temperature | Time |
| ||
| (°C) | (°F) | (minutes) | ||||
|
|
| |||||
|
|
|
|
|
|
| |
0.7 lb / 300 gr (*) | 190 | 370 | phase 1 | 5 | - 6 | ||
|
|
|
|
| phase 2 | 2 | - 3 |
Potato croquettes |
| 1.1 lb / 500 gr | 190 | 370 | 7 - 8 |
| |
|
|
|
|
|
|
| |
Fish | 0.7 lb / 300 gr | 190 | 370 | 6 - 7 |
| ||
| Prawns | 0.7 lb / 300 gr | 190 | 370 | 6 - 7 |
| |
Meat | Chicken cutlets (2) |
0.4 lb / 200 gr
190
370
7 - 8
(*)This is the recommended quantity for excellent results. Naturally a larger quantity of frozen potatoes can be fried, taking into consideration that they will be a little more greasy due to the sudden drop in the temperatu- re of the oil, upon immersion.
TROUBLESHOOTING
Anomaly | Cause | Solution | |
|
|
| |
Unpleasant odours | Change the filter | ||
| The oil or fat has deteriorated | Change the oil (or fat) | |
| The oil or fat is not suitable | Use a | |
|
|
| |
The oil overflows | The basket has been lowered too quickly into the oil | Lower the basket slowly | |
| Too much oil in the fryer | Reduce quantity of oil in the fryer | |
| Food not dried sufficiently before immersing in the oil | Dry the food thoroughly | |
| Recommended max. quantity exceeded |
| |
|
| 2.2 lb / 1 kg (fresh potatoes) | |
|
|
| |
| Fryer has been previously switched on without oil in | Contact Service Centre (fuse | |
Oil does not heat | pot causing the thermal | change necessary) | |
The magnetic convector is not correctly inserted | Insert the connector with the jut | ||
| |||
|
| “X” on the top side | |
|
| Contact the Service Centre | |
|
|
|
9