STEP 4 - LEVEL THE DRYER
1.Place the dryer in its Þnal location. Take care not to crush or kink the exhaust vent. Make sure that all four feet are Þrmly in contact with the ßoor and that the dryer rests solidly in position.
NOTE: For a gas dryer, make sure that there are no kinks in the ßexible gas line.
2.Using a carpenter’s level, check to make sure the dryer is level from side to side and from front to back.
3.If the dryer is not level, adjust the leveling feet. Turn clockwise to extend (raise the dryer) or counterclockwise to retract (lower the dryer).
STEP 5 - COMPLETE THE INSTALLATION
1.Plug the dryer power cord into an appropriate outlet.
2.Resume power to the outlet. Check to make sure the circuit breaker is switched on.
3.Dispose of/recycle all packaging materials.
4.Make sure the dryer area is clean and free from combustible materials, gasoline, and other ßammable vapors. Also see that nothing (such as boxes, clothing, etc.) obstructs the ßow of combustion and ventilation air through the louvered panel located on the rear of the dryer.
5.Test dryer operation by selecting a Timed Dry heated cycle. See the “Operating Instructions” section.
NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds, the Þrst time the dryer is turned on, the safety switch will shut o the burner. If this happens, turn the dryer to “OFF” and wait 5 minutes before making another attempt to light the burner.
19