Haier RDG350AW, CRDE350AW user manual

1. Turn the gas supply o by moving the shut-o valve to the closed position.

Closed Valve	A
Open Valve	B

2.Disconnect and discard old ßexible gas connector. Replace with a new CSA(AGA) approved ßexible gas connector.

3.Remove the shipping cap from the gas inlet pipe at the rear of the dryer.

4.Connect a !" NPT elbow to the gas inlet pipe on the dryer. Then connect a ßare adapter to the elbow.

IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.

Gas Inlet Pipe on
the Dryer
³⁄₈" NPT Elbow	A	C
³⁄₈" NPT Flare Adapter		B

5.Connect the dryer to the gas supply line with a ßexible gas connector.

Flexible Gas Connector A

6.Tighten the ßexible gas connector using two adjustable wrenches.

7. Turn the gas supply on by moving the shut-o valve to the open position. The valve is open when the handle is parallel to the gas pipe.

17