Maytag MD55 warranty Step, Controls AT a Glance

CONTROLS AT A GLANCE

Step 1

Senshutsor Dry – automatically senses the moisture in the load

and the dryer off when the selected dryness level (very dry to damp dry) is reached.This cycle is recommended for the majority of loads including delicates, wrinkle free and cotton/sturdy items like towels, bedding and jeans.

Or

Time Dry – may be selected for any load if sensor dry is not used. Press the “+” or “–” time pad to select the desired number of minutes.

Step 2

Dry Temp – there are four temperature settings. Press the up “ ” or down “ ” pads to select regular, medium, delicate or extra low temperatures.

RegularDry.” – for sturdy cottons or those labeled “Tumble Medium – for permanent press, synthetics, lightweight cot- tons or items labeled “Tumble Dry Medium.”

Delicate – for heat sensitive items labeled “Tumble Dry Low” or “Tumble Dry Warm.”

Extra Low – provides the lowest heated dry temperature possible. Extra low temperature is lower than delicate.

Step 3

SelselectDryndesiredss Level – press the “ ” or “ ” arrow pads

to the dryness level.The dryness level can be set on or between a setting.

Very Dry – used to completely dry sturdy or bulky items including towels and jeans.

Normal – used for drying the majority of loads.

Dthatmp Dry – designed to partially dry items. Used for items lay flat or hang to dry.

Step 4

Setting the Signal – the end of cycle signal is adjustable. Press the “+” or “–” signal pad to increase or decrease the volume of the signal.

5