Maytag W10240585B-SP, MGDE200XW Electric Dryer Power HOOKUP- Canada only, Electrical Requirements

Page 7

Closet Installation (stacked washer and dryer):

6"

(152 mm)

For gas dryers mobile home installations:

■■ Mobile Home Installation Hold-down Kit Part Number 346764 is available to order. For further information, see "Assistance or Service" section in your Use and Care Guide.

3"

(76 mm)

76"

(1930 mm)

51/2"

(140 mm)

3"

(76 mm)

1"

1"

(25 mm)

(25 mm)

 

48in.2

(310 cm2)

24in.2

(155 cm2)

ELECTRIC DRYER

POWER HOOKUP- CANADA ONLY

ELECTRICAL REQUIREMENTS

WARNING

Electrical Shock Hazard

Plug into a grounded 4 prong outlet.

Failure to do so can result in death or electrical shock.

Custom under counter installation (dryer only):

39" min.

(990 mm)

1"

(25 mm) 1"

(25 mm)

NOTE: Some models not recommended for undercounter installation.

Mobile home - Additional installation requirements:

This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile home construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH.

Mobile home installations require:

All dryers:

■■ Metal exhaust system hardware, available for purchase from your dealer. For further information, see “Assistance or Service” section in your Use and Care Guide.

■■ Special provisions must be made in mobile homes to introduce outside air into dryer. Openings (such as a nearby window) should be at least twice as large as dryer exhaust opening.

It is your responsibility:

■■ To contact a qualified electrical installer.

■■ To be sure that the electrical connection is adequate and in conformance with Canadian Electrical Code, C22.1-latest edition and all local codes. A copy of above codes standard may be obtained from: Canadian Standards Association, 178 Rexdale Blvd., Toronto, ON M9W 1R3 CANADA.

■■ To supply the required 4 wire, single phase, 120/240 volt, 60 Hz, AC only electrical supply on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit.

■■ This dryer is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-30R wall receptacle. The cord is 5 ft. (1.52 m) long. Be sure wall receptacle is within reach of dryer’s final location.

4-wire receptacle (14-30R)

If using a replacement power supply cord, it is recommended that you use Power Supply Cord Replacement Part Number 9831317.

7

Image 7
Contents Table of Contents Your safety and the safety of others are very important Dryer SafetyWhat to do if YOU Smell GAS Parts supplied steam models Installation Requirements Tools and PartsTools needed for gas installations Tools needed for all installationsFront view Dryer DimensionsLocation Requirements You will needCabinet installation dryer only Closet installation dryer onlyBack view Electrical Requirements Electric Dryer Power HOOKUP- Canada onlyNatural Gas GAS Dryer Power HookupGAS Supply Requirements GAS TypeDryer GAS Pipe GAS Supply LineGAS Supply Connection Requirements Burner Input RequirementsVenting REQUiREMENTS Installation InstructionsPlan Vent System Alternate exhaust installations for close clearanceChoose your exhaust installation type Optional exhaust installationsInstall Leveling Legs INStall Vent SystemConnect Inlet Hose Make GAS ConnectionTurn on cold water faucet Attach long hose to Y connector and tighten couplingsTighten couplings Attach long hose to dryer fill valve and tighten couplingLevel dryer Connect ventDoor Reversal Complete InstallationChecklist TroubleshootingVotre sécurité et celle des autres est très importante Sécurité de la sécheuseQUE Faire Dans LE CAS D’UNE Odeur DE GAZ Pièces fournies tous les modèles Exigences Dinstallation Outillage ET PiècesOutils nécessaires aux installations au gaz Outils nécessaires pour toutes les installationsVue de face Exigences DemplacementDimensions DE LA Sécheuse Il vous faudraVue arrière Installation dans un placard sécheuse seulement Toutes les sécheuses Installation sous comptoir personnalisée sécheuse seulementSpécifications Électriques Cest à lutilisateur quincombe la responsabilité deType DE GAZ Raccordement Dune Sécheuse À GAZInstructions DE Liaison À LA Terre Conservez CES InstructionsCaractéristiques Dalimentation DU Brûleur Conversion pour lalimentation au propaneCanalisation DE GAZ Exigences Concernant LE Raccordement AU GAZExigences Concernant Instructions Pour LInstallationLévacuation Planification DU Système Dévacuation Installations dévacuation facultativesDispositions spéciales pour les maisons mobiles Raccorder le conduit dévacuation au clapet Installation DU Circuit DévacuationInstaller le clapet dévacuation Tableau des systèmes dévacuationRaccordement AU GAZ Installation DES Pieds DE NivellementFixer le long tuyau au raccord en Y et serrer les raccords Raccordement DU Tuyau Darrivée DeauFixer le tuyau court et le raccord en Y Serrer les raccordsOuvrir le robinet deau froide 16. Déplacer la sécheuse à son emplacement finalRaccordement DU Conduit Dévacuation Raccorder le conduit dévacuation à la bouche dévacuationSerrer et ajuster les pieds de nivellement Achever Linstallation Liste DE VérificationRéglage DE Laplomb DE LA Sécheuse 17. Régler laplomb de la sécheuseDépannage Inversion DE LA PorteW10240584B W10240585B-SP