Maytag W10240585B-SP Installation Requirements Tools and Parts, Parts supplied steam models

INSTALLATION REQUIREMENTS

TOOLS AND PARTS Tools needed for gas installations:

Gather the required tools and parts before starting installation.

Tools needed for all installations:

8" or 10" pipe wrench	8" or 10" adjustable wrench
	(for gas connections)

Flat-blade screwdriver #2 Phillips screwdriver

		Pipe-joint compound
		resistant to LP gas
		Parts supplied (all models):
Wire stripper (direct wire	Tin snips (new vent
installations)	installations)

		Leveling legs (4)
1/4" nut driver	Vent clamps
		Parts supplied (steam models):
(recommended)

Tape measure

Pliers

“Y” connector

Long inlet hose

Short inlet hose

Rubber washer

Level	Caulking gun and compound
	(for installing new exhaust vent)

Adjustable wrench that	Utility knife
opens to 1" (25 mm) or
hex-head socket wrench

Parts package is located in dryer drum. Check that all parts are included.

NOTE: If installing dryer on pedestal, do not use leveling legs.

Check local codes. Check existing electrical supply and venting. See “Electrical Requirements” and “Venting Requirements” before purchasing parts.

Check code requirements. Some codes limit, or do not permit, installing dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.

Optional Equipment: (Not supplied with dryer)

Refer to your Use and Care Guide for information about accessories available for your dryer.

4