Installing and Configuring the PassageWay
Service Provider
New PassageWay Service Provider
Users
This section applies to new PassageWay Service Provider users. If you have an existing version of the PassageWay Service Provider or PassageWay Solution, proceed to the next section, “Upgrading the PassageWay Service Provider or PassageWay Solution.”
If you are a new PassageWay Service Provider user, perform the following steps:
1.Read the section “PassageWay Service Provider Components” to make sure that you have all of the PassageWay Service Provider components.
2.Read the section “PassageWay Service Provider Requirements” to make sure that you have the required hardware and software to run the PassageWay Service Provider.
3.Read the section “Before You Begin” to make sure that you have the necessary information to set up the PassageWay Service Provider.
4.Connect your PassageWay adapter to your PC and your telephone by performing the procedures in the section “Installing the PassageWay Adapter.”
5.Install the PassageWay Service Provider by performing the procedures in the section “Installing the Software.”