Sterling SSPET 5 operating instructions For the operating safety of the equipment

Page 13
Safety instructions 12

SM4-630

SSPET5

1.4. For the operating safety of the equipment

Never change settings if the consequences are not precisely known.

Use only original Sterling spare parts.

Please observe the maintenance intervals.

Keep record of all maintenance and repair procedures.

Please note that electronic sub-assemblies can be damaged by static dis- charges.

Check all electrical connections for proper fit before the equipment is taken into operation for the first time and at regular intervals.

Never adjust sensors without exact knowledge of their function.

Please note that the ambient temperature of the control unit must not exceed 45°C (113°F).

Adjust the suction pipes properly.

Please observe that a level indicator is required when conveying from granulators.

Mount the single conveyor unit in such a way that the outlet flap swings in a right-hand angle to the direction of machine movement.

Please ensure that all plugs are correctly plugged in.

Observe the bearing capacity of the machine flange.

The operating instructions of the machines to which it is connected should be obeyed.

Image 13
Contents Sterling Material Processing SspetParts and Service Department Telephone 800 Edition 02/01 Sterling order confirmation no Technical serviceSSPET5 Table of contents Technical data Parts list Accessories MaintenanceSafety instructions Safety instructionsSSPET5 Explanations and information For your safety SSPET5 SSPET5 For the operating safety of the equipment Assembly instructions Assembly Assembly SM4-630 Mounting the suction pipe MV Electrical connection Installation of the signal line of the SKW optional Installation of the flap switch signal lineSSPET5 Compressed-air supply Functional description General Controller SSE SSPET5 Controller SSP Putting into operation Checking the pipe system If the conditions points 3 + 4 are not met Adjusting the suction pipesIf the conditions points 3 + 4 are met Setting the conveying time Setting the controller SSETurbine is running but no material is being conveyed Conveying capacity is too lowChange-over key Setting the line clear timeSetting the time interval Setting the controller SSPInitial conveying operations Alarm Messages displayed on the controller SSESSPET5 Switching off the unit Alarm Messages displayed on the controller SSPMaintenance SSPET5 Maintenance intervals Servicing the conveyor Removal InstallationChanging the sealing ring of the outlet flap Adjusting the flap switch Replacing carbon brushes at turbine Installation Optional Features Technical dataTechnical data Basic VersionDimension Sheet Parts list SSPET5 Pos Order no Designation Accessories