Sterling SSPET 5 operating instructions Setting the line clear time, Change-over key

Page 31

SSPET5

Setting the line clear time

Press the “arrow key” and

the “change-over” key.

&

F

The line clear time which was last selected appears in the display.

0-99 seconds may be set for the line clear time.

If no line clear valve has been installed enter “0".

SM4-630

Putting into operation 30

Image 31

Contents Sterling Material Processing SspetParts and Service Department Telephone 800 Edition 02/01 Sterling order confirmation no Technical serviceSSPET5 Table of contents Technical data Parts list Accessories MaintenanceSafety instructions Safety instructionsSSPET5 Explanations and information For your safety SSPET5 SSPET5 For the operating safety of the equipment Assembly instructions Assembly Assembly SM4-630 Mounting the suction pipe MV Electrical connection Installation of the signal line of the SKW optional Installation of the flap switch signal lineSSPET5 Compressed-air supply Functional description General Controller SSE SSPET5 Controller SSP Putting into operation Checking the pipe system If the conditions points 3 + 4 are not met Adjusting the suction pipesIf the conditions points 3 + 4 are met Conveying capacity is too low Setting the controller SSESetting the conveying time Turbine is running but no material is being conveyedChange-over key Setting the line clear timeSetting the time interval Setting the controller SSPInitial conveying operations Alarm Messages displayed on the controller SSESSPET5 Switching off the unit Alarm Messages displayed on the controller SSPMaintenance SSPET5 Maintenance intervals Servicing the conveyor Removal InstallationChanging the sealing ring of the outlet flap Adjusting the flap switch Replacing carbon brushes at turbine Installation Basic Version Technical dataOptional Features Technical dataDimension Sheet Parts list SSPET5 Pos Order no Designation Accessories