SSPET5
The following error messages can be displayed:
“E1"
The alarm message “E1" is displayed when no material has been conveyed du- ring 3 consecutive conveying cycles.
Check that sufficient material is being conveyed.
Check that the flap switch is set correctly.
F
“E2"
When the malfunction has been corrected press the key.
If the control system becomes too hot during operation (>70°C) (158°F) the “E2" alarm message is displayed and the unit is switched off.
Ensure that the control system is sufficient cooled.
&
The unit starts automatically after the cooling down phase.