Sterling SSPET 5 operating instructions SSPET5

Page 11

SM4-630

SSPET5

Do not modify, add other equipment or change the design of the equipment with- out the approval of the manufacturer. Caution: Danger of accidents!

Compile detailed operating instructions based on these operating instructions for the sequence of procedures to be carried out on this equipment.

Improper operation results in danger of accidents!

Appoint an equipment foreman to be responsible for the equipment.

Ensure that the operating personnel are provided detailed instruction in the oper- ation of the equipment. Improper operation results in danger of accidents!

When the main switch is switched off for reasons pertaining to safety, it must be secured against unauthorized activation. Caution: Danger of accidents!

Before starting maintenance work, appoint a supervisor.

Inform the responsible personnel before maintenance work on the system is started. Caution: Danger of accidents!

Disconnect the equipment from mains supply before starting maintenance proce- dures to ensure that it cannot be switched on unintentionally.

Caution: Danger of accidents!

Repair work may be carried out by trained personnel only. Caution: Danger of accidents!

Never operate the equipment when partially dismantled.

Caution! Danger exists that limbs may be caught; danger of electrical shock!

In case of malfunction, shut down the equipment immediately. Have malfunctions corrected immediately. Caution: Danger of accidents!

The equipment is intended only for conveying granulated plastics and additives. Other use of the equipment is contrary to its specifications.

Safety instructions 10

Image 11
Contents Sterling Material Processing SspetParts and Service Department Telephone 800 Edition 02/01 Sterling order confirmation no Technical serviceSSPET5 Table of contents Technical data Parts list Accessories MaintenanceSafety instructions Safety instructionsSSPET5 Explanations and information For your safety SSPET5 SSPET5 For the operating safety of the equipment Assembly instructions Assembly Assembly SM4-630 Mounting the suction pipe MV Electrical connection Installation of the signal line of the SKW optional Installation of the flap switch signal lineSSPET5 Compressed-air supply Functional description General Controller SSE SSPET5 Controller SSP Putting into operation Checking the pipe system If the conditions points 3 + 4 are met Adjusting the suction pipesIf the conditions points 3 + 4 are not met Conveying capacity is too low Setting the controller SSESetting the conveying time Turbine is running but no material is being conveyedChange-over key Setting the line clear timeSetting the time interval Setting the controller SSPInitial conveying operations Alarm Messages displayed on the controller SSESSPET5 Switching off the unit Alarm Messages displayed on the controller SSPMaintenance SSPET5 Maintenance intervals Servicing the conveyor Removal InstallationChanging the sealing ring of the outlet flap Adjusting the flap switch Replacing carbon brushes at turbine Installation Basic Version Technical dataOptional Features Technical dataDimension Sheet Parts list SSPET5 Pos Order no Designation Accessories