Sterling SSPET 5 operating instructions Setting the controller SSE, Setting the conveying time

Page 30

SSPET5

4.3. Setting the controller SSE

F

&

The filling capacity of the hopper loader may not exceed the material inlet.

The setting is independent of the conveying line and the ma- terial to be conveyed.

It is only possible to set the conveying time / line clear time when the unit is not conveying any material.

Setting the conveying time

Press the “arrow key”.

&

The conveying time which was last selected appears in the display.

1-99 seconds may be set for the conveying time.

The turbine is running but no material is being conveyed:

Reduce the conveying time.

The conveying capacity is too low:

Increase the conveying time.

SM4-630

Putting into operation 29

Image 30

Contents Sspet Sterling Material ProcessingParts and Service Department Technical service Telephone 800 Edition 02/01 Sterling order confirmation noSSPET5 Table of contents Maintenance Technical data Parts list AccessoriesSafety instructions Safety instructionsSSPET5 Explanations and information For your safety SSPET5 SSPET5 For the operating safety of the equipment Assembly instructions Assembly Assembly SM4-630 Mounting the suction pipe MV Electrical connection Installation of the flap switch signal line Installation of the signal line of the SKW optionalSSPET5 Compressed-air supply Functional description General Controller SSE SSPET5 Controller SSP Putting into operation Checking the pipe system Adjusting the suction pipes If the conditions points 3 + 4 are not metIf the conditions points 3 + 4 are met Turbine is running but no material is being conveyed Setting the controller SSESetting the conveying time Conveying capacity is too lowSetting the line clear time Change-over keySetting the controller SSP Setting the time intervalAlarm Messages displayed on the controller SSE Initial conveying operationsSSPET5 Alarm Messages displayed on the controller SSP Switching off the unitMaintenance SSPET5 Maintenance intervals Servicing the conveyor Installation RemovalChanging the sealing ring of the outlet flap Adjusting the flap switch Replacing carbon brushes at turbine Installation Technical data Technical dataOptional Features Basic VersionDimension Sheet Parts list SSPET5 Pos Order no Designation Accessories