Sterling SSPET 5 Initial conveying operations, Alarm Messages displayed on the controller SSE

Page 33

SSPET5

4.5. Initial conveying operations

Metal shavings may be inside the pipe from cutting down pipes into lengths. The- se are pulled during the first conveying process and collected in the separator.

F

This material should not be used again.

4.6. Alarm Messages displayed on the controller SSE

If a disturbance occurs in the unit, an alarm message will be issued (option, only if the alarm indicating device has been activated).

&

F

An “E” appears in the display and an error number.

The alarm indicating device (signal siren, horn) reacts.

The control system can only restart operation when the mal- function has been corrected.

Press the “acknowledgement key”.

&

SM4-630

The cause of the malfunction will not be corrected by pres- sing the “acknowledgement key”.

Putting into operation 32

Image 33

Contents Sterling Material Processing SspetParts and Service Department Telephone 800 Edition 02/01 Sterling order confirmation no Technical serviceSSPET5 Table of contents Technical data Parts list Accessories MaintenanceSafety instructions Safety instructionsSSPET5 Explanations and information For your safety SSPET5 SSPET5 For the operating safety of the equipment Assembly instructions Assembly Assembly SM4-630 Mounting the suction pipe MV Electrical connection Installation of the signal line of the SKW optional Installation of the flap switch signal lineSSPET5 Compressed-air supply Functional description General Controller SSE SSPET5 Controller SSP Putting into operation Checking the pipe system Adjusting the suction pipes If the conditions points 3 + 4 are not metIf the conditions points 3 + 4 are met Setting the conveying time Setting the controller SSETurbine is running but no material is being conveyed Conveying capacity is too lowChange-over key Setting the line clear timeSetting the time interval Setting the controller SSPInitial conveying operations Alarm Messages displayed on the controller SSESSPET5 Switching off the unit Alarm Messages displayed on the controller SSPMaintenance SSPET5 Maintenance intervals Servicing the conveyor Removal InstallationChanging the sealing ring of the outlet flap Adjusting the flap switch Replacing carbon brushes at turbine Installation Optional Features Technical dataTechnical data Basic VersionDimension Sheet Parts list SSPET5 Pos Order no Designation Accessories