MasterCraft 2009 MariStar X-Series owner manual Safety checks and services, Before Each Operation

Page 38

safety checks and services

The following checks and services are essential to safe boating and must be performed. Get in the habit of perform- ing these checks in the same order each outing so that it becomes routine.

DO NOT launch or operate the boat if any problem is found during the Safety Check. A problem could lead to an accident dur- ing the outing, resulting in death or seri- ous injury. Any and all problems should receive attention immediately. See your authorized MasterCraft dealer’s service department for assistance.

Before Each Operation

These tasks are best accomplished before the boat is launched.

•Follow all engine and drive train pre-operation maintenance and safety checks as outlined in the engine owner’s manual provided.

•Check the weather report, wind and water conditions.

•Check for recommended on-board tools and parts.

•Check that all drain plugs are installed properly, including bilge and rear drain.

•Check the propeller and shaft for damage.

•Check that there is an adequate supply of fuel.

•Check that the steering system operates properly.

•Check that required safety equipment is on board.

•Check that the windshield and extrusions do not show any damage.

When boating, avoid using the windshield as an aid for balance or getting out of a seat. This causes undue stress to the window frame and could damage it, which may not be covered under warranty.

•Check that the fire extinguisher is fully charged.

•Check that no fuel, oil or water is leaking or has leaked into

the bilge compartment.

•Check all hoses and connections for leakage or damage.

•Check that all required Scheduled Maintenance Checks and Services (see following sections) were performed.

During Operation

•Check gauges frequently for operating conditions.

•Pay attention that controls operate smoothly.

•Note any excessive vibration.

After Operation

•Check for fluid leaks.

•In boats equipped with a ballast system, drain water from the ballast system before placing the boat on the trailer. If the boat has ballast-pumping assistance to remove water from the ballast system, note that the engine must be running at least 1500 RPM during the pumping process (for both fill and empty operations). This will necessitate draining water prior to ceasing operation of the boat and loading on the trailer. More information regarding ballast systems appears in vari- ous sections of this Owner’s Manual.

•Check the fins (where equipped), propeller, rudder and shaft for damage after removing the boat from the water.

MasterCraft 2009 Owner’s Manual - Page 7-1

Page 37 Page 39
Image 38
Page 37 Page 39
Contents 2009 MasterCraft Welcome aboard Page 2-1 Page 16-2, 16-5, Page Table of contents Boating safety General PrecautionsRequired Equipment Safety EquipmentSafety Afloat Recommended EquipmentSkiing and Wakeboarding Safety Operator’s License Common sense approach Rules of the open water Sailing Vessel Right-of-Way OvertakingOther Special Situations Fishing Vessel Right-of-WayGuide to individual models Exhaust Bow Light Transom Drain Plug MariStar Fuel Tank Engine Batteries Filler Star CSX Instrument panels Measurements All Models-Actual Switch Usage Will Vary Accessory SwitchesAft Light Switch Volt ReceptacleAttitude Adjustment or Trim Tab Switch MariStar 230, X-30, MariStar 245 MariStar 280Blower Switch Ballast Empty/Fill SwitchesManual and Automatic Bilge Pump Switch Manual Circuit BreakersDisplay Selector Switch Clock Adjustment SwitchCourtesy Lights Switch Dual Battery Operation SwitchEngine Oil Pressure Gauge Engine Hatch SwitchEngine Synchronizing Switch MariStar 280/X-80, CSX-220, CSX-265Low Voltage Battery Alarm Heater SwitchInstrument Panel Gauge Backlighting Switch Fuel GaugeRefrigerator Switch Navigation/Anchor Lights SwitchOther Alarms Seat Heat SwitchesTemperature Gauge Shower and/or Slick Boot SwitchSink Switch Shift/Throttle ControlTower Lights Switch Video Display GaugePage Wash Down Switch VoltmeterUsing care when fueling What Type of Gasoline To UseWhen Fuel Runs Out or Too Low for Proper Operation When the Boat Is Not Used for a WhileUsing Oxygenated Fuels or Fuels with Alcohol Fuels Outside United States and CanadaPage During Operation Safety checks and servicesBefore Each Operation After OperationAfter Break-In New boat break-inFirst Hours of Operation Page Shifting Gears Before StartingStarting the Engine Underway StoppingOperational hints Page Unusual Operating Conditions Docking and Tie-UpLifting the boat Using Lifting EyesUsing Lifting Slings Storage CradleGalvanic Corrosion Corrosion preventionMarine Growth Stainless Steel and ChromeUpholstery Cleaning the boatHull Fiberglass Swim Platform CarpetTeak Wood WindshieldUnacceptable Upholstery Cleaners Slick BootAcceptable Upholstery Cleaners Enclosed HeadApco Mastercraft boat care products MasterCraft Marine Motor Oil & Filters MasterCraft Cleaning & Detailing KitMasterCraft Microfiber Detailing Cloths Before Each Use Frequency and Scheduled MaintenanceNew Boat Break-In After Each UseQuarterly Every Fifty 50 Hours Annually Every One Hundred 100 HoursCheck Raw Water Intake Strainer where equipped Inspect the Battery Connections and Hold-DownsBy the warranty Inspect the Propeller Shaft Log for Water EntryInspect the Fuel System for Leaks Inspect the Exhaust System for LeaksCheck That the Battery Is Fully Charged General Cleaning and StorageLubricate the Engine Starter Gear and Shaft Check the Engine MountsLubricate the Steering System Check the Propeller Shaft Coupling AlignmentInspect the Exhaust Flaps for Damage Inspect the Complete Fuel System for Leakage Lubricate the Shift and Throttle SystemCheck the Ballast Pump Impeller Fire Extinguisher and Suppression Units Fuel System Treatment General Power Package PreparationGeneral Preparation Other Winterization Preparations Ballast System Preparations Re-Activating the Boat After StorageChecking/Repairing Propellers Changing PropellersAnchor and Windlass Battery ChargerComfort and convenience Coolers Fire Suppression and ExtinguishingGPS and Chartplotter HeadHeater Before operationLivewell/Kill Box/Catch Box Hydraulic Steering SystemLighting RefrigerationSeat Heaters Shower or Wash DownSwim/Boarding Platforms Stereo EquipmentTables Folding Down the PlatformWater Heater TowersVideo Screen Guide to troubleshooting Limited warranty statement Page Page Page Warranty registration and transfer Warranty Registration TransferService log Every 100 Hours DateIndex 12-1Gauge, Voltmeter Gauges & Switches, Variations Platforms, Swim/Boarding 19-7 Storage & Winterization 17-1 19-9 Transfer, Warranty Registration 22-1 ProStar MariStar Series Saltwater Series

2009 MariStar X-Series specifications

The 2009 MasterCraft MariStar X-Series stands out as a remarkable blend of luxury and performance in the world of wakeboarding and recreational boating. Designed for enthusiasts who demand the best, this model encapsulates everything that differentiates MasterCraft's prestigious line of boats.

The MariStar X-Series boasts a sleek, aerodynamic hull that not only enhances its visual appeal but also contributes to its superior handling and smooth ride. With a length of 22 feet, it provides plenty of space for friends and family while maintaining the agility required for wake sports. The deep-V hull design effectively cuts through choppy waters, creating a stable and comfortable experience for passengers.

One of the standout features of the MariStar X-Series is its powerful engine options. The boat offers a range of high-performance engines, allowing users to select the power that best suits their needs. With options that can deliver up to 350 horsepower, the MariStar ensures exhilarating speed and excellent torque for wakeboarding, wake surfing, and other water activities.

The boat’s unique ballast system is designed to enhance the quality of the wakes produced, allowing for optimal wakeboarding conditions. The integrated system lets users easily fill and drain water ballast to customize the wake shape and size, ensuring that every rider gets the best possible experience.

Inside, the cabin of the 2009 MariStar X-Series is a testament to luxury and convenience. Plush seating provides comfort, while the premium sound system delivers high-quality audio perfect for a day out on the water. The cockpit is laid out for easy access to controls, making it user-friendly for both seasoned drivers and novices.

Additional features include a foldable bimini top that provides shade during sunny outings and ample storage compartments for gear. The attention to detail extends to the materials used in the upholstery, which are not only stylish but also durable and easy to maintain.

Overall, the 2009 MasterCraft MariStar X-Series combines performance, technology, and luxury in a single package. Its innovative design and features cater to both recreational users and serious water sports enthusiasts, making it a cherished choice for those looking to elevate their on-water experience.
Top Page Image Contents