MasterCraft 2009 MariStar X-Series owner manual Quarterly Every Fifty 50 Hours

Page 55

Quarterly (Every Fifty [50] Hours)

Note: MasterCraft recommends that the following functions be performed by authorized MasterCraft technicians at an autho- rized MasterCraft dealer.

Before the engine has been started or after it has cooled:

•Lubricate the engine starter gear and shaft.

•Check the safety equipment.

Annually (Every One

Hundred [100] Hours)

Note: MasterCraft recommends that the following be performed by authorized MasterCraft technicians at an autho- rized MasterCraft dealer.

Before the engine has been started or after it has cooled:

•Replace the fuel filter (to be per- formed by an authorized MasterCraft technician only).

•Check the propeller shaft coupler alignment.

•Lubricate the steering system.

•Lubricate the throttle and shift cables.

•Check the engine mounts.

•Inspect the complete fuel system for leakage.

•Check the fire extinguisher and sup- pression units on-board.

Details follow in the next few sections.

MasterCraft recommends that many of these functions be performed by authorized MasterCraft technicians at an authorized MasterCraft dealer!

MasterCraft 2009 Owner’s Manual - Page 15-2

Page 54 Page 56
Image 55
Page 54 Page 56
Contents 2009 MasterCraft Welcome aboard Page 2-1 Page 16-2, 16-5, Page Table of contents General Precautions Boating safetyRecommended Equipment Safety EquipmentSafety Afloat Required EquipmentSkiing and Wakeboarding Safety Operator’s License Common sense approach Rules of the open water Fishing Vessel Right-of-Way OvertakingOther Special Situations Sailing Vessel Right-of-WayGuide to individual models Exhaust Bow Light Transom Drain Plug MariStar Fuel Tank Engine Batteries Filler Star CSX Instrument panels Measurements Volt Receptacle Accessory SwitchesAft Light Switch All Models-Actual Switch Usage Will VaryMariStar 230, X-30, MariStar 245 MariStar 280 Attitude Adjustment or Trim Tab SwitchCircuit Breakers Ballast Empty/Fill SwitchesManual and Automatic Bilge Pump Switch Manual Blower SwitchDual Battery Operation Switch Clock Adjustment SwitchCourtesy Lights Switch Display Selector SwitchMariStar 280/X-80, CSX-220, CSX-265 Engine Hatch SwitchEngine Synchronizing Switch Engine Oil Pressure GaugeFuel Gauge Heater SwitchInstrument Panel Gauge Backlighting Switch Low Voltage Battery AlarmSeat Heat Switches Navigation/Anchor Lights SwitchOther Alarms Refrigerator SwitchShift/Throttle Control Shower and/or Slick Boot SwitchSink Switch Temperature GaugeVideo Display Gauge Tower Lights SwitchPage Voltmeter Wash Down SwitchWhat Type of Gasoline To Use Using care when fuelingFuels Outside United States and Canada When the Boat Is Not Used for a WhileUsing Oxygenated Fuels or Fuels with Alcohol When Fuel Runs Out or Too Low for Proper OperationPage After Operation Safety checks and servicesBefore Each Operation During OperationFirst Hours of Operation New boat break-inAfter Break-In Page Starting the Engine Before StartingShifting Gears Stopping UnderwayOperational hints Page Docking and Tie-Up Unusual Operating ConditionsStorage Cradle Using Lifting EyesUsing Lifting Slings Lifting the boatStainless Steel and Chrome Corrosion preventionMarine Growth Galvanic CorrosionHull Cleaning the boatUpholstery Windshield CarpetTeak Wood Fiberglass Swim PlatformEnclosed Head Slick BootAcceptable Upholstery Cleaners Unacceptable Upholstery CleanersApco Mastercraft boat care products MasterCraft Microfiber Detailing Cloths MasterCraft Cleaning & Detailing KitMasterCraft Marine Motor Oil & Filters After Each Use Frequency and Scheduled MaintenanceNew Boat Break-In Before Each UseAnnually Every One Hundred 100 Hours Quarterly Every Fifty 50 HoursInspect the Battery Connections and Hold-Downs Check Raw Water Intake Strainer where equippedInspect the Propeller Shaft Log for Water Entry By the warrantyInspect the Exhaust System for Leaks Inspect the Fuel System for LeaksGeneral Cleaning and Storage Check That the Battery Is Fully ChargedCheck the Engine Mounts Lubricate the Engine Starter Gear and ShaftInspect the Exhaust Flaps for Damage Check the Propeller Shaft Coupling AlignmentLubricate the Steering System Check the Ballast Pump Impeller Lubricate the Shift and Throttle SystemInspect the Complete Fuel System for Leakage Fire Extinguisher and Suppression Units General Preparation General Power Package PreparationFuel System Treatment Other Winterization Preparations Re-Activating the Boat After Storage Ballast System PreparationsChanging Propellers Checking/Repairing PropellersComfort and convenience Battery ChargerAnchor and Windlass Fire Suppression and Extinguishing CoolersHead GPS and ChartplotterBefore operation HeaterRefrigeration Hydraulic Steering SystemLighting Livewell/Kill Box/Catch BoxShower or Wash Down Seat HeatersStereo Equipment Swim/Boarding PlatformsFolding Down the Platform TablesVideo Screen TowersWater Heater Guide to troubleshooting Limited warranty statement Page Page Page Warranty Registration Transfer Warranty registration and transferEvery 100 Hours Date Service log12-1 IndexGauge, Voltmeter Gauges & Switches, Variations Platforms, Swim/Boarding 19-7 Storage & Winterization 17-1 19-9 Transfer, Warranty Registration 22-1 ProStar MariStar Series Saltwater Series
Top Page Image Contents