Fostex VM08 owner manual Directly recalling a scene memory, Clearing a scene memory

Model VM08 Owner’s Manual

Directly recalling a scene memory

In addition to the method described earlier in "Scene recall," a scene memory can also be recalled directly using the following method of stepping consecutively through the stored scenes.

< Note >

Only user scene memories (scene numbers [01]--[20]) can be selected using this method of direct recall. Preset scene number [00] cannot be recalled.

1.Hold down the EXIT key and press the SCENE RECALL key.

Blinking

2.Press the EFF 1 key or EFF 2 key.

Pressing the EFF 2 key will make the scene number change in the forward direction. Pressing the EFF 1 key will make the scene number change in the backward direction.

3.To exit this mode, press the EXIT key.

You will exit scene direct recall mode and return to normal mix mode.

Lit Lit

<Useful Information!>

Scene direct recall can also be performed using a separately sold foot switch.

If you connect an unlatch type foot switch (e.g., model 8051) to the FOOT SW jack, you can use the foot switch to perform the procedure described above.

When you press the foot switch, you will enter scene direct recall mode, and pressing the foot switch again will step through the scene numbers. If you hold down the foot switch, you will return to the previous scene number. Here too, you can press the EXIT key to exit scene direct recall mode.

In order to use a foot switch to recall scenes, you must make the appropriate setting in "Setup mode" described later in this manual. For details refer to "Setup mode" on the following page.

Clearing a scene memory

Here's how to clear a specific scene memory.

1.Simultaneously hold down the SCENE RECALL key and SCENE STORE key.

The number and name of the currently selected scene will be displayed.

2.Rotate the DATA encoder to select the scene number that you wish to clear, and press the ENTER key.

The display will ask whether you wish to clear the selected scene number. (The example screen shown here is when you have selected scene number [02].)

3.Press the ENTER key.

The scene memory will be cleared.

<Note >

If you select scene number [00] and attempt to clear it, the display will indicate [Read Only], and the operation will be ignored. Only scene numbers [01]--[20] can be cleared.

Lit

The display will indicate [Clear 02 ?], and [?] will blink.

26