Korg D3200 owner manual 112, Ch View, Channel Routing View, 3a. Rename, 3b. Program number cell

2.Recall

This button loads (recalls) a mixer setup program.

In the mixer setup list, click the program that you want to recall.

Click this button to open the Recall dialog box, verify the program that you are recalling, and click the Yes button (or press the panel YES key). If you decide not to recall the program, click the No button (or press the panel NO key).

A program you saved from a 44.1 kHz or 48 kHz song can be recalled to either a 44.1 kHz or a 48 kHz song.

3.Store

This button stores the current mixer settings as a mixer setup program.

Verify the store-destination number, and click the Yes button (or press the panel YES key). If you decide not to store, click the No button (or press the panel NO key).

3a

3b

3a. Rename

You can click this button and rename the mixer setup program (→p.99).

3b. Program number cell

This selects the store-destination program number. Click this cell to highlight it, and then use the value dial (or +/– keys) to select the desired number.

3. CH VIEW

3-1. Ch View

This displays the settings and status for a single channel. To select the channel that you want to view, press the CH SE- LECT key and then press the channel key of the desired channel.

In this screen you can set the following parameters.

•Pairing (→p.102)

•Pan (→p.103)

•Channel on/off (→p.8)

•Input (→p.101)

•Attenuator (→p.107)

•Phase (→p.108)

•Recording location (→p.110)

•Solo on/off (→p.110)

•EQ on/off, flat (→p.107)

•Fader (→p.103)

•Level meter position (→p.99)

•Group (→p.102)

•Send (→p.109)

•EQ (→p.107)

To edit the Send and EQ parameters, use the Knob Matrix lo- cated below the display.

3-2. Channel Routing View

This displays a simplified signal flow for the channel shown in the “Ch View” tab page.

You cannot edit the settings here.

To select the channel that you want to view, press the CH SELECT key and then press the channel key of the desired channel.

112