Korg D3200 owner manual Pan, 116, Master EFF2, Final EFF, Effect return

2. Trim knob [0…100]

With a setting of 100, the level will be the same as the input level.

If distortion is caused by an excessively high input level when you apply the effect, use this parameter to lower the input level.

3.Effect chain display

This shows the chain of effects that make up the effect program.

4.Knob icons

Use these to edit the parameters of each effect.

For details, refer to “4-2. Insert EFF” (→p.114), 7. Knob icons.

5.ON/OFF

This is an on/off switch for the selected effect within the effect chain.

If the button is OFF, that effect will be bypassed.

6.Level meter

This shows the input/output level of the effect and the GR (gain reduction) level.

7.Effect return

Sets the effect return level and balance.

8.Rename

Use this to rename an effect program.

For details, refer to “4-2. Insert EFF” (→p.115), 10. Rename.

9.Store

Use this to store the effect program whose parameters or

name you have edited.

For details, refer to “4-2. Insert EFF” (→p.115), 11. Store.

4-4. Master EFF2

For details on the parameters, refer to the section above, “4- 3. Master EFF1.”

2. Trim knob [0…100]

With a setting of 100, the level will be the same as the input level.

If distortion is caused by an excessively high input level when you apply the effect, use this parameter to lower the input level.

3.Effect chain display

This shows the chain of effects that make up the effect program.

4.Knob icons

Use these to edit the parameters of each effect.

For details, refer to “4-2. Insert EFF” (→p.114), 7. Knob icons.

5.ON/OFF

This is an on/off switch for the selected effect within the effect chain.

If the button is OFF, that effect will be bypassed.

6.Level meter

This shows the input/output level of the effect and the GR (gain reduction) level.

7.Rename

Use this to rename an effect program.

For details, refer to “4-2. Insert EFF” (→p.115), 10. Rename.

8.Store

Use this to store the effect program whose parameters or

name you have edited.

For details, refer to “4-2. Insert EFF” (→p.115), 11. Store.

5. SEND

Operation is the same as when you press the MIXER key and click the SEND (EFF/AUX/REC) button in the page jump menu screen. For the parameters, refer to “2e. SEND (EFF/ AUX/REC)” (→p.109).

4-5. Final EFF

The final effect is used to make final adjustments to the over- all sound in the last stage of the master bus. Here you can use one stereo effect program.

You can use the Knob Matrix located below the LCD screen to edit the parameters that are shown as knob icons.

	1
2		6
3
4
	7
5		8

1.Effect program selection

To select an effect program, use the value dial, or click the popup button in the screen and choose from the list of effect programs displayed by category.

If the selected program has been edited, the program number’s P (preset), U (user), or S (song) indication will change to “E,” indicating that the program has been edited.

6. EQ

This displays the 2d-1. EQ/ATT tab page. For the parame- ters, refer to “2d-1. EQ/ATT” (→p.107).

7. PAN

This displays the 2c-1. Fader Pan tab page. For the parame- ters, refer to “2c-1. Fader Pan” (→p.103).

116