Korg KM-2 manual Contents

Contents / Connections and controls of the KM-2
Contents
Connections and controls of the KM-2	2
Effect program list	4
Operation	5
Calibrating the crossfader	7
Specifications	8
Connections and controls of the KM-2
Top panel

1. Channel 1 input select switch Selects the input source for channel 1. Note: If you wish to select the mic as the input source, set the front panel TALK OVER ON/OFF switch (F1) to the OFF position.

LINE: CD player, etc. MIC: mic

PHONE: turntable

TALK OVER :ON :OFF

2. Channel 2 input select switch Selects the input source for channel 2.

3. PEAK (peak indicator), TRIM (trim knob) Adjust the trim knob so that the peak indi- cator does not light even for high volume levels.

4. HIGH EQ (high equalizer)

Adjusts the amount of boost/cut for the high range equalizer.

5. MID EQ (middle equalizer)

Adjusts the amount of boost/cut for the mid range equalizer.

6. LOW EQ (low equalizer)

Adjusts the amount of boost/cut for the low range equalizer.

7. Channel 1 fader

Adjusts the volume of channel 1.

8. Channel 2 fader

Adjusts the volume of channel 2.

9. FX DEPTH (effect depth) knob

At the CUT position, no effect will be ap- plied to the sound. At the FULL position, the maximum effect will be applied to the sound. Normally you will leave this in the FULL position.

Front panel

F1. TALK OVER ON/OFF switch

When this switch is ON (pressed in), the audio from the mic input will be mixed into the master output.

✩ If you are using the mic as the input for channel 1, set the TALK OVER switch to OFF.

F2. MIC LEVEL knob

Adjusts the volume level of the mic.

F3. MIC input jack

Connect a mic to this jack.

Note: The mic input is an unbalanced input.

F4. X-FADE(cross fade curve switch)

Selects the curve of the cross-fader.

F5. PHONES (headphone) jack

Connect a set of headphones to this jack.

2