Omega RD260A instruction manual Setting Chart Speed Chart, Chart Speed unit mm/h

6.5 Setting Chart Speed (CHART)

6.5 Setting Chart Speed (CHART)

Chart Speed (unit: mm/h)

10	15	20	25	30	40	50	60	75	80
90	100	120	150	160	180	200	240	300	360
375	450	600	720	750	900	1200	1500	1800	2400
3000	3600	4500	4800	5400	6000	7200	9000	10800	12000

The data for a dot-printing model (10 mm/h to 1500 mm/h) are shown within the bold border.

Key operation

ESC

DISP

3 sec

PRINT

CH UP

PRINT

CH UP

Indication Description

Press the [DISP] key for three seconds to enter the SET mode,

and select [ ] using the [ ] key. Then press the [ENT] key.

Using the [ ] key, select one of the two kinds of chart speed, the No.1 and No.2 chart speeds. Then press the [ENT] key.

NOTE

PRINT

CH UP

NOTE

	ESC
CH UP	DISP	3 sec

The No.2 chart speed identifies the chart speed which takes effect in case the speed is changed by remote control (optional function).

For models without the remote control function, the setting of the No.2 chart speed is invalid.

Select a numeric code referring to the table above using the [ ] key and press the [ENT] key.

Digital printing will not be carried out when the chart speeds are: 120 mm/h or more for a dot-printing model

When a pen model uses a fast chart speed such as 600 mm/h to 1500 mm/h, the position error of the time tick of a periodic printout may become as large as 2 cm for 1500 mm/h.

[ ] is dispalyed and the setting is completed. Press the [ENT] key to set another channel; or press the [DISP] key for three seconds to return to the OPERATION mode.

6. SET

NOTE If you press the [ESC] key in the middle of setting, the indication returns to the

[ ] and already set data will be aborted.

MODE

6 - 15