7.4 Setting Upscale/Downscale TC Burnout
7.4 Setting Upscale/Downscale TC Burnout
The purpose of the following setting is to specify where the pens will move in the case of a
The initial value is ‘UP’, and ‘OFF’ for every channel.
SETTING PROCEDURE:
Enter the SET UP mode by turning ‘ON’ the power while pressing and holding the [CH
UP] (
ENT) key until the SET UP display appears.
Use the [
] key to select the display [
]. Press the [ENT] key.
Use the [
] key to select the display [
]. Press the [ENT] key.
Select [ | ] or [ | ] using the [ ] key. Press the [ENT] key. |
The display [ | ] appears. | |
This burnout processing is ON/OFF selectable per channel. Press the [ENT] key.
Use the [
] key to select the display [
]. Press the [ENT] key.
Select the channel No. using the [
] key for which you want to specify this burnout processing. Then press the [ENT] key.
Select ‘ON’ or ‘OFF’. Then press the [ENT] key. The display [
] appears.
Before leaving the SET UP mode, you have to store your new settings. Use the [
] key
to select the [
] display, and press the [ENT] key.
Select [
] to keep your new settings or [
] to abort the settings, and press the [ENT] key. After a few seconds, the OPERATION mode will appear.
7. SET UP MODE
7 - 5