7.17 Turning the Settings Protection Function On/Off
You can protect your settings made in the SET or SET UP modes using a password.
• If you select ‘OFF’:
the choice does not affect operation in any mode.
• If you select ‘ON’:
you must type in a password to enter the SET or SET UP mode. The password discussed here is one you set in the following procedure.
The initial value is ‘OFF.’
SETTING PROCEDURE:
Enter the SET UP mode by turning ‘ON’ the power while pressing and holding the [CH UP] (
ENT) key until the SET UP display appears.
Use the [ | ] key to select the display [ | ]. Press the [ENT] key. |
Use the [ | ] key to select ‘ON’ or ‘OFF’. Press the [ENT] key. In the case you | |
selected Off, the setting is completed. |
| |
Set a password in 
] key and the [ 
] key. After
setting is finished, press the [ENT] key. The display [ | ] appears. |
NOTE Never forget the password.
Before leaving the SET UP mode, you have to store your new settings. Use the [
] key
to select the [ 
] display, and press the [ENT] key.
Select [ 
] to keep your new settings or [ 
] to abort the settings, and press the [ENT] key. After a few seconds, the OPERATION mode will appear.
7 - 18