KitchenAid KFRU271VSS Make Gas Connection To a 20 lb LP Gas Fuel Tank, Drawer Style Tank Tray

Make Gas Connection - To a 20 lb LP Gas Fuel Tank

WARNING

Explosion Hazard

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

4.Screw the gas pressure regulator/hose assembly to the 20 lb LP gas fuel tank as shown. (To disconnect, turn off the gas supply to the 20 lb LP gas fuel tank, then unscrew the gas pressure regulator/hose assembly from the 20 lb LP gas fuel tank as shown.)

connect

disconnect B

A

If converting to local LP or Natural gas, follow instructions in the “Gas Conversions” section.

LP Gas:

IMPORTANT: A 20 lb LP gas fuel tank must be purchased separately.

IMPORTANT: The gas pressure regulator/hose assembly supplied with the grill must be used. Replacement gas pressure regulator/hose assembly specific to your model, is available from your outdoor grill dealer.

Drawer Style Tank Tray

To Install the 20 lb LP Gas Fuel Tank:

1.Open the drawer for the 20 lb LP gas fuel tank.

2.Place the 20 lb LP gas fuel tank bottom collar into the mounting hole in the tank tray

3.Tighten the locking screw against the bottom collar of the 20 lb LP gas fuel tank to secure.

A

BC

A.Locking screw

B.Mounting hole

C.Bottom collar

A. 20 lb LP gas fuel tank

B. Gas pressure regulator/hose assembly

5.Turn on the gas supply. Wait a few minutes for gas to move through the gas line.

6.Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found.

7.Slide the drawer with the 20 lb LP gas fuel tank back into the cabinet.

8.The batteries are not factory installed. The 1.5-volt “D” size alkaline batteries are located in the accessory box on the grill grate. Install the batteries at this time following the instructions in the “Replacing the Batteries” section.

9.Go to “Plug in Grill” in this section.

Door Style Tank Tray

To Install the 20 lb LP Gas Fuel Tank:

1.Open cabinet doors.

2.Press the locking tab on the tank tray and pull out the tray..

A

A. 20 lb LP gas fuel tank tray locking tab

3.Place the 20 lb LP gas fuel tank bottom collar into the mounting hole in the tank tray.

11