NORMAL OPERATION
Match Lighting Your Rotisserie Burner
Follow the simple steps listed below to match light the Rotisserie Burner of grill, in the event electronic ignition fails:
1. Open the lid and make sure that all burners are in the “OFF” position.
DANGER: Failure to open the lid while igniting the Rotisserie Burner, or not waiting 5 minutes to allow the gas to clear
if the Rotisserie Burner does not light, may result in an explosive
2.Turn main gas supply on.
3.Remove warming rack. NOTE: Always remove the warming rack when using the rotisserie.
4.Put match in the match holder and strike match.
WARNING: Do not lean over an open barbecue.
5.Push the ROTISSERIE BURNER control knob in and turn to “high”. Continue to hold the ROTISSERIE BURNER control knob in until 20 seconds after the burner has ignited. Then release the ROTISSERIE BURNER control knob.
6.Hold match holder and lit match to the middle of the Rotisserie Burner to ignite.
WARNING: If burner does not light, turn the selected burner control knob to OFF and wait 5 minutes to let the gas clear before trying again to light burner(s).
7.Verify Rotisserie Burner has ignited by visual inspection of a flame. (The burner will glow red.)
WARNING: Never leave a grill unattended. This will guard against possible grease fires getting out of control. Grease fires can be severe and cause grill damage, property damage and bodily harm.
WARNING: Please remember that this is an outdoor gas cooking appliance. Many areas of the grill generate extreme heat. We have taken every precaution to protect you from the contact areas. However, it is impossible to isolate all
17