Kenmore 141.173373, 141.153373 owner manual FOOT\SIDE Burner

6.For Natural Gas grills:

Connect the Electric Wire terminal from Side Burner

with the other from Grill Head. See Figure 8d. Bind the connected Electric Wires, and Connection Tube

together using the supplied Fastening Band.

7.The gap between the Side Burner Electrode Tip and the Side Burner Port should be approximately 1/8"~3/16". See Figure 8e. If the gap is wider than 3/16", use a pair of long nose pliers and gently bend the Electrode Tip toward the Burner.

8.Slide the 5 Tool Hooks onto the Tool Holder with hooks facing the grill Head. Attach Tool Holder to left side of Side Shelf and secure firmly using 2 of the M5x8mm Pattern Head Screws and washers supplied. See Figure 8f.

•When you have finished assembling your grill we strongly urge that all Pattern Head Thumb Screws be tightened, either with the supplied Tightening Tool or a #2 Phillips Head Screwdriver.

Tightening Tool

Ref. # P05515102K

Figure 8d (Natural Gas model only)

SIDE BURNER POT SUPPORT

\\\\\

_StDBBURNER

			COTTER PIN
		\
CONTROL		SiDE BURNER		FRAME
KNOB_
	_StDE	BURNER		GAS
		VALVE	ASSEMBLY
FASTENING
BAND	_	ELECTRIC WIRE
		FROM	SiDE	BURNER

\\

\

ELECTRIC WIRE

FROM GRILL HEAD

Figure 8e

1/8"-3/16"BURNER PORT

9.For Natural Gas grills:

Connect the hose end of the 12' Natural Gas Hose to the vertical fitting as shown in Figure 8g. Also read the natural gas safety instruc- tions. (on page 4)

Figure 8g (Natural gas model only)

BRASSADAPTOR, f SIDE BURNER GAS VALVE

12'NATURAL GAS HOSE

CONNECTION TUBE

FROM GRILL HEAD

FOOT\SIDE BURNER

Figure 8f

TOOL HOOK

TOOL HOLDER

M5x8rnm PATTERN

HEAD SCREW

SiDE SHELF

18