Aussie Bonza Deluxe, Kanga owner manual

Page 3

7. WARNING! If your grill catches on fire:

If the fire is in the grill portion and you can safely reach the control knobs, then turn them off by turning knobs clockwise. If you cannot safely reach the control knobs, call the fire department.

If the fire involves one of the hoses, and you can safely reach the propane cylinder valve, shut the valve off by turning LP cylinder valve handle clockwise to a full stop.

If the fire involves the cylinder, leave it alone, evacuate the area and call the fire department.

If there is any type of fire that threatens either personal safety or endangers property, call the fire department.

8.Check the Bottom Body Panel for grease buildup. Remove excess grease to avoid a grease fire in the pan.

Never use the grill without Bottom Body Panel and Grease Tray in place.

9. WARNING! If you notice grease or other hot material dripping from the grill onto valve, hose, or regulator, turn off gas supply immediately. After the grill has cooled, determine the cause and correct it. After cleaning the valve, hose and regulator, perform a leak test before continuing use. See Before Using Your LP Gas Grill section of this manual for correct leak test procedures.

10.This installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1, or CAN/CGA-B149.2, Propane Installation Code.

11.If an external electrical source is utilized, the outdoor cooking appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Codes, ANSI/NFPA 70, or the Canadian Electrical Code. CSA C22.1.

12.Keep any electrical supply cord and the fuel supply hose away from any heated surfaces. Electric cords should be placed away from walkways to avoid a tripping hazard.

13.Combustible materials should never be within

36 in. of the back or sides of your LP gas grill.

14.Never apply polyurethane to the wood cart while the grill is in use or hot. Allow polyurethane to completely dry before using.

15.The Vinyl grill cover must be removed and placed at least 36 inches from LP gas grill while in use. The grill cover is made of a flammable material. The grill must be cooled before putting the cover back on the grill.

16. WARNING! Always Store Lp Cylinders upright and where temperatures do not exceed 125 degrees Fahrenheit. Never store a spare or disconnected LP cylinder under or near this LP gas grill.

17.Check the LP gas grill for gas leaks and burner obstructions before each use.

WARNING! Do not use a flame to check for gas leaks. See Before Using Your LP Gas Grill section of this manual for correct leak test procedures. A clogged burner tube can lead to a fire beneath grill.

18. DANGER! If you see, smell, or hear the hiss of escaping gas from the LP cylinder:

A.Get away from the cylinder.

B.Do not attempt to correct the problem yourself.

C.Call your local fire department.

19. WARNING! Do not operate an LP gas grill if you have knowledge of or suspect a gas leak.

20.Always inspect the gas hose and regulator assembly before each use. Always turn the LP cylinder to the “Off” position before inspecting parts. If the hose is cut, damaged, or showing signs of excessive abrasion or wear, do not use the LP gas grill. Contact the manufacturer, as the hose must be replaced with an assembly specified by the manufacturer prior to further use of the LP gas grill.

21. WARNING! Before lighting the LP gas grill, open

the lid or hood to prevent an explosion from gas build-up. The lid (KangaTM series only) must never cover the cooking surface while the grill is in use or hot.

See Operation of Your LP Gas Grill section

22.If any burner does not light, turn off all gas control knobs. Leave the grill lid or hood open and wait five minutes before attempting to light.

23.If any burner goes out during operation, turn off all gas control knobs. Open the hood (on Bonza™) and wait five minutes before attempting to light.

24.Excercise reasonable care when using this LP gas grill. Never leave grill unattended during use or cleaning.

25.Never allow children to operate or play near an LP gas grill. Keep animals and bystanders out of the grill area.

26.Always turn off the LP gas cylinder at the cylinder valve when not in use. Allow grill to cool before handling parts or cleaning.

27. WARNING! Do not move an LP gas grill when in

use or hot.

28. WARNING! Never touch hot surfaces. Use heat resistant gloves, long-handled tongs, or cooking mitts at all times. The grill will become very hot. Open the hood carefully when cooking to avoid burns from the hot air and steam trapped inside.

3

Image 3
Contents AussieTM Important Safeguards Page Am 5 pm E.S.T Mon. Fri Telephone PART/DESCRIPTION BonzaKanga Bonza QTY Kanga Bonza PART/ DescriptionPART/ Descripton PART# QTY. Kanga Bonza 47 6mm Item 1, 2, or 4 Side Table X 1 3/8 Bolt 8pcs X 1 Bolt 8 pcs Wheel LEG/ Side Table Assembly ToolsTear Drop Table Shown Fixed LEG/SIDE Table Assembly ToolsItem 9 8 pcs Item 10 8 pcsX 1 Bolt 8 pcs Pcs Legbrace Assembly ToolsX 2 Bolt Wood 1/4 X 1 3/8 Bolt Metal Bottom SHELF/LEG & Caster Assembly ToolsItem 19, 20 X 1 Bolt Wood LEG 1/4 x 1 3/8 Bolt MetalX 1/2 Bolt WHEEL/ Cylinder Bracket Assembly ToolsItem 23, 24 Item 27 4 pcsItem 31 6mm x 110mm Bolt 8 pcs Item 32 6mm Wing NUT Grill BODY/CART ASSEMBLY- Kanga Models ToolsAssembly Next Item 30 Spacer 8 pcs6mm X 110mm Assemble Grill Body to CART- Kanga ModelsGrill BODY/CART ASSEMBLY- Bonza & Bonza Deluxe Models Tools Item 32 6mm Wing NUT 8pcsItem 31 Actual Size 6mm x 110mm Bolt Pcs Grill BODY/CART ASSEMBLY- Bonza Models Continue Assembly of Bonza & Bonza Deluxe Models AT Step6mm x 110mm Bolts Or 4 PCS Install Burner ToolsAttach Decorative Privacy Panel to Cart ALL Models NextAdjust Tab if greater than 3/16 Cotter PIN Install from underneath Backside of grill16 GAP Install Bottom Body PANEL/GREASE TRAY- ALL Models Install Ceramic Briquette Trays & Grids ALL Models#8 X 1/2 Screw 2pcs Attach Handle to Weather Cover LID Kanga Models Tools SCREW, #10 X 3/8#10 X 3/8 Screw Attach Handle and Heat Indicator to Hood Bonza Models Tools FIG. K Attach LP Cylinder to Grill ALL ModelsHow to perform a leak test Leak Testing to be Performed in a WELL-VENTILATED AreaConnecting/ Disconnecting LP Gas Cylinder to Grill GAS, CYLINDER, Hose Regulator InformationLP Gas Cylinder Before Using Your LP GAS Grill PrecautionsSelecting a Location Operating the LP GAS Grill LeakTestingConfirm each burner is lit before lighting another burner Lighting the Grill Using the Integra Spark Ignition SystemPreparation Before Cooking Turn LP cylinder handle counter-clockwise onManual Lighting of the Grill Grill Cooking Care and MaintenanceCheck Your Flame End of Cooking Session Turn off Your LP Gas GrillHow to clean procelain coated cast iron burners Burner MaintenanceBottom Panel/ Grease Tray Cleaning the Grill BodyPreventive Maintenance Ceramic BriquettesLow flame or low heat Using the ignitorUsing a match Burners will not lightFlames blow out Flare upPersistent grease fire Important Notice Aussie Grill Company Limited Warranty