Aussie Bonza Check Your Flame End of Cooking Session, Turn off Your LP Gas Grill, Grill Cooking

Page 30

Check Your Flame

 

End of Cooking Session

 

 

 

Your burners have been preset by the manufacturer for opti- mal flame performance. A blue flame, possibly with a small yellow tip, is the result of the optimal air and LP gas mix- ture. (See diagram below)

Yellow Tip

·Never leave your LP gas grill unattended during use or cleaning.

After each cooking session, close the hood (Bonza™ series only) and turn the grill burners to the “high” position and burn for five minutes. This procedure will burn off cook- ing residue, thus making cleaning easier.

Turn off Your LP Gas Grill

Primarily Blue

Flame

The flame should be checked before the initial cooking ses- sion and periodically throughout the grilling season, espe- cially after storing the grill over a long period of time. If the flame is significantly yellow in color, then you are not getting the appropriate amount of LP gas in the air /LP gas mixture. This could be a result of a blocked burner from grease drip- pings or from insects building a nest inside the burner or burner opening. You should follow the Burner Maintenance section of this manual for cleaning the burners.

Grill Cooking

The cast iron burners heat up the Ceramic Briquettes underneath the grill, which in turn heats the food on the grill. The natural food juices produced during cooking fall onto the hot Ceramic Briquettes below and vaporize. The subse- quent rising smoke bastes the food, as it travels upwards, giving it that unique barbecued flavor.

Roasting Hood Cooking

(Bonza & Bonza Deluxe Series Only)

Grills equipped with a roasting hood give the option of cooking with hood closed to form an ‘oven’ for roasting food, such as roasts of meat, whole chickens, etc. When the hood is closed, a large amount of heat is trapped inside the grill. Thus, it is IMPORTANT to make sure that all the burners are turned to the low position to prevent burning of the food. Avoid lifting the hood unnecessarily as heat is lost every time the hood is opened. Use the temperature gauge to check the approximate temperature inside the grill.

·The grill must be completely cooled before putting the Grill Storage Cover (55) back on the grill.

How to turn off your LP gas grill

1)When you have finished using your grill, turn the grill Control Knobs clockwise to the “Off” position.

2)Turn off the gas at the LP cylinder valve by turning the handle clockwise completely until it stops.

3)Wait until the grill is cool before closing the grill’s lid or closing its hood.

4)After the LP gas grill has cooled, put the Grill Cover (55) on the grill.

WARNING! Never store an LP gas cylinder indoors (empty or filled). If storing the gas grill

indoors, disconnect LP gas cylinder and store it outdoors out of the reach of children.

CARE AND MAINTENANCE

·Always turn off the LP gas cylinder, at the LP cylinder valve, when not in use. Allow the grill to cool before handling parts or cleaning.

·Do not move an LP gas grill when in use or hot.

·Never touch hot surfaces. Use heat resistant gloves, long-handled tongs, or cooking mitts at all times since grill will become very hot.

·Do not wear loose clothing (for example: hanging shirt tails, clothing with frills, etc.) around a LP gas grill while in use or hot.

·Never lean your body over the LP gas grill when lighting it or while it is in use or hot.

·Never douse the grill with water when its surfaces are hot because it may cause grease to splatter or the porcelain cooking grids and hood to break.

30

Image 30
Contents AussieTM Important Safeguards Page Am 5 pm E.S.T Mon. Fri Telephone PART/DESCRIPTION BonzaKanga Bonza PART/ Description QTY Kanga BonzaPART/ Descripton PART# QTY. Kanga Bonza 47 6mm Wheel LEG/ Side Table Assembly Tools Item 1, 2, or 4 Side Table X 1 3/8 Bolt 8pcs X 1 Bolt 8 pcsItem 10 8 pcs Fixed LEG/SIDE Table Assembly ToolsItem 9 8 pcs Tear Drop Table ShownLegbrace Assembly Tools X 1 Bolt 8 pcs PcsX 1 Bolt Wood LEG 1/4 x 1 3/8 Bolt Metal Bottom SHELF/LEG & Caster Assembly ToolsItem 19, 20 X 2 Bolt Wood 1/4 X 1 3/8 Bolt MetalItem 27 4 pcs WHEEL/ Cylinder Bracket Assembly ToolsItem 23, 24 X 1/2 BoltItem 30 Spacer 8 pcs Grill BODY/CART ASSEMBLY- Kanga Models ToolsAssembly Next Item 31 6mm x 110mm Bolt 8 pcs Item 32 6mm Wing NUTAssemble Grill Body to CART- Kanga Models 6mm X 110mmGrill BODY/CART ASSEMBLY- Bonza & Bonza Deluxe Models Tools Item 32 6mm Wing NUT 8pcsItem 31 Actual Size 6mm x 110mm Bolt Pcs Grill BODY/CART ASSEMBLY- Bonza Models Continue Assembly of Bonza & Bonza Deluxe Models AT Step6mm x 110mm Bolts Next Install Burner ToolsAttach Decorative Privacy Panel to Cart ALL Models Or 4 PCSAdjust Tab if greater than 3/16 Cotter PIN Install from underneath Backside of grill16 GAP Install Bottom Body PANEL/GREASE TRAY- ALL Models Install Ceramic Briquette Trays & Grids ALL Models#8 X 1/2 Screw 2pcs Attach Handle to Weather Cover LID Kanga Models Tools SCREW, #10 X 3/8#10 X 3/8 Screw Attach Handle and Heat Indicator to Hood Bonza Models Tools Attach LP Cylinder to Grill ALL Models FIG. KLeak Testing to be Performed in a WELL-VENTILATED Area How to perform a leak testConnecting/ Disconnecting LP Gas Cylinder to Grill GAS, CYLINDER, Hose Regulator InformationLP Gas Cylinder Before Using Your LP GAS Grill PrecautionsSelecting a Location LeakTesting Operating the LP GAS GrillTurn LP cylinder handle counter-clockwise on Lighting the Grill Using the Integra Spark Ignition SystemPreparation Before Cooking Confirm each burner is lit before lighting another burnerManual Lighting of the Grill Turn off Your LP Gas Grill Care and MaintenanceCheck Your Flame End of Cooking Session Grill CookingBurner Maintenance How to clean procelain coated cast iron burnersCeramic Briquettes Cleaning the Grill BodyPreventive Maintenance Bottom Panel/ Grease TrayBurners will not light Using the ignitorUsing a match Low flame or low heatFlames blow out Flare upPersistent grease fire Important Notice Aussie Grill Company Limited Warranty