CARE AND MAINTENANCE
(Continued)
Regularly clean your LP gas grill between uses and espe- cially after extended periods of storage. Ensure the grill and its components are cool before cleaning. In order to extend the life and maintain the condition of your grill, we strongly recommend that the unit be covered when stored outside for any length of time, especially during the winter months.
Porcelain coated Cooking Surfaces And Hood (Bonza™ Series Only)
Most residue on the Cooking Grids can be cleaned with a baking soda and water solution. For stubborn stains, use a non abrasive scouring powder. Do not use steel wool or other like cleaning products on the porcelain coated sur- faces. This will scratch the porcelain coating causing foods to stick.
Burner Maintenance
·Check the LP gas grill for gas leaks and burner obstructions before each use.
·Always turn off the LP gas cylinder at the
LP cylinder valve when not in use. Allow grill to cool before handling parts or cleaning.
Provided that the burners are operating correctly, in normal usage, burning off the residue after cooking will keep the burners clean. The burners should be removed and cleaned annually, or whenever heavy
How to clean procelain coated cast iron burners |
| the burner surfaces. (See Figure below) Verify that there | |
1) | Make sure the LP cylinder and Grill control knobs are |
| are no insects or insect nests blocking the inlet hole. |
| turned off. (See Figure below) |
| Note: It is normal for surface rust to be present on the |
2) | Carefully remove Cooking Grids and Ceramic Briquettes. |
| burners. |
3) | Remove the burners, by first removing cotter pin from | 6) | Once all burners are cleaned, place each burner back |
| each burner peg located at rear end of burner. (See |
| into grill and reinstall cotter pin. Note: When refitting |
| Figure below) |
| the burners, be careful to check that they are |
4) | Remove each burner from the grill. |
| positioned correctly. (Refer to Step 9 of Assembly |
5) | Clean burners. Use a pipe cleaner to clear obstructions |
| Instructions for reinstallation) |
| from the burner holes and inlet hole. A brass wire brush | 7) | Assemble Ceramic Briquette Trays and then Cooking |
| can be used to remove corrosion and food particles from |
| Grids. |
2.Remove grids and ceramic
trays. | 3 & 4. Remove cotter pins and burners |
| from grill. (Follow steps below.) |
|
|
3rd - Slide burn-
er back
1) Turn the LP Cylinder han- 
dle clockwise
until it stops.
2nd - Lift rear of burner up
1st - Pull cotter pin out
5.Use a pipe cleaner to clear obstructions from all burner holes. A brass wire brush can be used on the burner surfaces to remove cor- rosion.
31