| TROUBLESHOOTING | 13 |
|
|
|
|
|
PROBLEM | CHECK | CURE |
|
|
|
|
|
Burners burn with a yellow or orange flame, in | Inspect Spider / Insect Screens for possible obstructions. | Clean Spider / Insect Screens. (See Section “Annual |
|
conjunction with the smell of gas. | (Blockage of holes.) | Maintenance”) |
|
|
|
|
|
Symptoms: | The excess flow safety device, which is part of the | To reset the excess flow safety device turn all burner control |
|
Burners do not light. | barbecue to cylinder connection, may have activated. | knobs and the cylinder valve to OFF. Disconnect the regulator |
|
flickering flame in the HI position. |
| from the cylinder. Turn burner control knobs to HI. Wait at |
|
Barbecue temperature only reaches 250˚ to 300˚ |
| least 1 minute. Turn burner control knobs to OFF. Reconnect |
|
in the HI position. |
| the regulator to the cylinder. Turn cylinder valve on slowly. |
|
|
| Refer to “Lighting Instructions”. |
|
|
|
|
|
Burner does not light, or flame is low in HI | Is LP fuel low or empty? | Refill LP cylinder. |
|
position. |
|
|
|
| Is fuel hose bent or kinked? | Straighten fuel hose. |
|
|
|
|
|
| Does the Left burner light with a match? | If you can light the Left burner with a match, then check the |
|
|
| Crossover® ignition system. |
|
|
|
|
|
Experiencing | Are you preheating barbecue in the prescribed manner? | All burners on high for 10 to 15 minutes for preheating. |
|
|
|
|
|
| Are the cooking grates and Flavorizer® bars heavily | Clean thoroughly. (See Section “Cleaning”) |
|
| coated with |
|
|
CAUTION: Do not line the bottom tray |
|
|
|
Is the bottom tray “dirty” and not allowing grease to flow | Clean bottom tray |
| |
with aluminum foil. | into catch pan? |
|
|
|
|
|
|
Burner flame pattern is erratic. Flame is low when | Are burners clean? | Clean burners. (See Section “Maintenance”.) |
|
burner is on HI. Flames do not run the whole |
|
|
|
length of the burner tube. |
|
|
|
|
|
|
|
Inside of lid appears to be “peeling.” (Resembles | The lid is stainless steel, not paint. It cannot “peel”. What | Clean thoroughly. (See Section “Cleaning”.) |
|
paint peeling.) | you are seeing is baked on grease that has turned to |
|
|
| carbon and is flaking off. |
|
|
| THIS IS NOT A DEFECT. |
|
|
|
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
WWW.WEBER.COM®