Weber 89838 manual Side Burner Troubleshooting, Side Burner Maintenance

14	SIDE BURNER TROUBLESHOOTING
PROBLEM	CHECK	CURE
Side Burner burns with a yellow or	Inspect side burner orifice alignment	Loosen orifice and re-align orifice parallel to the side burner tube (3) .
orange flame, in conjunction with the	(Position of orifice to side burner tube.)	(See Section “Side Burner Maintenance”)
smell of gas.
Side Burner does not light.	Is gas supply off?	Turn supply on.
	The excess flow safety device, which is part	To reset the excess flow safety device turn all burner control knobs and the cylinder
	of the barbecue to cylinder connection, may	valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
	have activated.	START/HI. Wait at least 1 minute. Turn burner control knobs to “OFF”. Reconnect the
		regulator to the cylinder. Turn cylinder valve on slowly. Refer to “Lighting Instructions”.
Flame is low in “HI” position.	Is the fuel hose bent or kinked?	Straighten hose.
Push button ignition does not work.	Does burner light with a match?	If match lights burner, check igniter (see Sideburner Maintenance).

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

SIDE BURNER MAINTENANCE

WARNING: All gas controls and supply valves should be in the “OFF” position.

Make sure black wire is connected between the igniter and electrode. Make sure white wire is connected between the igniter and grounding clip. Spark should be a white/blue color, not yellow.

1)Igniter Wire

2)Ground wire

3)Burner

Side Burner Grate

Side Burner Grate

HeadHeadRetetentionClipClip

SideSideBurnerRingRing& &HeadHead

Igniter Electrode

Igniter Electrode

Control Knob

Control Knob

Igniter Button

Igniter Button

(3)

(2)

(1)

(2)

(1)

WARNING: The side burner orifice (4) must be parallel to the side burner tube opening (5).

(4)

(5)

WWW.WEBER.COM®