10 | GAS INSTRUCTIONS |
|
|
To Connect the hose to the cylinder:
1) Open base cabinet doors.
2) Pass the regulator hose through the side panel opening to the inside of the base cabinet.
3) Slide the hose retention bracket (1) along the hose and through the side panel opening to the inside of the base cabinet.
4) Position the hose retention bracket on the right inside panel and secure with two hex/washer/bolts (2).
WARNING: The hose must be secured to the side panel with the Hose Retention Bracket. Failure to do so could cause damage to the hose resulting in a fire or explosion which can cause serious bodily injury or death, and damage to property.
The LP cylinder is installed inside the base cabinet.
5) Turn the LP cylinder so the opening of the valve is either to the front, side or rear of the Weber® gas barbecue.
6) Lift and place the cylinder into the tank base opening in the bottom panel.
Weber recommends the use of cylinder manufacturer’s Manchester and Worthington, with a 47.6 lb water capacity. Other cylinders may be acceptable for use with the appliance provided they are compatible with the appliance retention means (see illustrations).
7) Remove the plastic dust cover from the valve.
8) Screw the regulator coupling onto the tank valve, clockwise, or to the right.
Note: This is a new type of connection. It tightens clockwise and will not allow gas to flow unless the connection is tight.The connection requires tightening by hand only.
WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.
You will need: LP cylinder, a soap and water solution and a rag or brush to apply it.
9)Mix soap and water.
10)Turn on the cylinder valve.
11)Check for leaks by wetting the fitting with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fitting. Turn the gas back on and recheck with the soap and water solution.
If leak does not stop, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. Do not use the barbecue.
12) When leak checking is complete, turn gas supply OFF at the source and rinse connections with water.
WWW.WEBER.COM®